3.3
I
NSTALLING
U
PRIGHTS
Locate the LEFT UPRIGHT (1). The upright is marked “L”. Position the LEFT UPRIGHT near inside of the left bracket.
a) Connect the two electrical connectors at the bottom of the upright.
b) Set the upright in position while feeding the cable into the upright.
c) Install all hardware and finger tighten at this time. Secure the LEFT UPRIGHT to the left bracket by using three
M8 X 60MM SILVER BOLTS (2) and three STAR WASHERS (3). Secure the front of the upright by installing one
M8 X 15MM SILVER BOLT (9) and one STAR WASHER (3).
CAUTION:
Do not pinch the wire when attaching the left upright to the left upright bracket. Carefully feed any excess
wire into the upright tube. Connectors must be inside the upright tube after installation.
Locate the RIGHT UPRIGHT (4). The upright is marked “R”. Position the RIGHT UPRIGHT near the inside of the right
bracket. Install all hardware and finger tighten at this time. Secure the RIGHT UPRIGHT to the right bracket by using
three M8 X 60MM SILVER BOLTS (2) and three STAR WASHERS (3). Secure the front of the upright by installing one
M8 X 15MM SILVER BOLT (9) and one STAR WASHER (3).
9
2
3
1
9
