Item
Weekly
Monthly
Biannually
Striding Belt Centered
Inspect
Emergency Stop Magnet
Clean / Inspect
Motor Cover
Clean
Vacuum / Clean
Motor Electronic
Compartment
Inspect
Drive Belt
Inspect
Leg Levelers
Inspect / Adjust
Front and Rear Rollers
Inspect
Side Step Area
Clean
Inspect
Side Hand Rails
Clean
Inspect
Ergo
™
Front Handlebar
Clean
Inspect
Troubleshooting the Treadmill
No power
Probable Cause
Corrective Action
ON / OFF switch is not in proper position.
Turn the switch to the ON position.
Power source is insufficient.
Plug treadmill into an appropriate circuit. Refer to
Grounding Instructions.
NOTE: In North America use a dedicated 20 amp circuit
for Commercial Units or a 15 amp circuit for Consumer
Units.
Using a voltmeter, verify power at outlet. If no power
exists, reset circuit breaker at panel.
Line cord is damaged.
Replace line cord. Contact
Life Fitness
Customer Support.
Line cord is improperly seated in socket.
Inspect power connections at wall outlet and at machine
for proper contact.
Striding belt slips off- center.
Probable Cause
Corrective Action
Floor surface is uneven.
Check levelers and level treadmill. Check striding belt &
re-tension as necessary. Refer to
How to Adjust and
Tension the Striding Belt.
Maximum speed is reduced.
Probable Cause
Corrective Action
User is pushing striding belt. This occurs when the runner
is running faster than the striding belt will travel, with the
result of the striding belt being pushed with the runner’s
feet.
Instruct users not to push striding belt in either direction.
User is stalling striding belt. This occurs with heavier users
at lower striding belt speeds. The striding belt will "stall"
if the user is traveling slower than the striding belt.
Page 15 of 35
