7
7.
Attach the 4-PIN (4P), 3-PIN (3P), and 16-PIN (16P) CON-
NECTORS to the corresponding JACKS on the back of the
CONSOLE ASSEMBLY (#4).
8.
Feed any excess WIRE HARNESS (E) down into the
CONSOLE SUPPORT ASSEMBLY (#7). Secure the CON-
SOLE ASSEMBLY (#4) to the CONSOLE SUPPORT
ASSEMBLY using four PHILLIPS PAN HEAD SCREWS
(#2). Tighten the SCREWS securely.
CAUTION: Do not over-tighten the PHILLIPS HEAD PAN
SCREWS (#2).
CAUTION: Be careful not to pinch the WIRE HARNESS
(E) when assembling the CONSOLE ASSEMBLY (#4) to
the CONSOLE SUPPORT ASSEMBLY (#7).
9.
Locate and install the CONSOLE SUPPORT CAP (#19)
onto the CONSOLE SUPPORT ASSEMBLY (#7) as
shown.
10. Locate the POLAR RECEIVER (#16). Slide the FOAM
ISOLATOR (#15) over the POLAR RECEIVER. Remove
the POLAR RECEIVER JACK (G) from the tape and plug
the POLAR RECEIVER into the POLAR RECEIVER JACK.
11. Locate the FRONT and BACK MONOCOLUMN COVERS
(#5 & #6). With the WIRE positioned on top, carefully
insert the POLAR RECEIVER (#16) between the vertical
ribs located inside the BACK MONOCOLUMN COVER
(#6).
Place the BACK MONOCOLUMN COVER (#6) over the
PIVOT SHAFT (H) at the top of the MONOCOLUMN (F).
NOTE: The POLAR RECEIVER WIRE must be positioned
on top when inserted into the REAR MONOCOLUMN
COVER (#6).
12. Place the FRONT MONOCOLUMN COVER (#5) on the
opposite side of the BACK MONOCOLUMN COVER (#6)
to cover the PIVOT SHAFT (G) and CONSOLE SUPPORT
ASSEMBLY MOUNTING SCREWS. Interlock the top tabs
and use two PHILLIPS PAN HEAD SCREWS (#3) to
secure the bottoms of the MONOCOLUMN COVERS
together. Tighten the SCREWS securely.
CAUTION: Do not over-tighten the PHILLIPS PAN HEAD
SCREWS (#3).
13. Locate one FRONT ROCKER COVER (#13) and one
BACK ROCKER COVER (#14). Position the FRONT
ROCKER COVER over the user side of the left end of the
PIVOT SHAFT (H) (as shown) making sure that it inter-
locks with the MONOCOLUMN COVERS (#5 & #6). Place
the BACK ROCKER COVER over the opposite side of the
left end of the PIVOT SHAFT in the same manner. Secure
the COVERS using three PHILLIPS PAN HEAD SCREWS
(#3). Repeat the procedure reversing front and back for the
user right end of the PIVOT SHAFT.
CAUTION: Do not over-tighten the PHILLIPS PAN HEAD
SCREWS (#3).
