7
0
1
2
3
4
5
6
1/2
1/2
1/2
1/2
1/2
1/2
FIGURE 1
STEP 1:
Insert two END CAPS (14) into FRAME (1)
Insert one LONGE TAPPED SHAFT (15) into frame (1) and one into BACK PAD SUPPORT (8),
Insert one SHORT TAPPED SHAFT (46) into SADDLE (3)
Attach two PLATES (9) one per side near bottom of frame and to BACK PAD SUPPORT (8)
using four 3/8 x 3/4 CAP SCREWS (36) and four 3/8 WASHERS (33)
Next attach BENCH FRAME (8) to BENCH SADDLE (3) using two 3/8 x 3/4 CAP SCREWS (36)
and two 3/8 WASHERS (33)
Simultaneously tighten both cap screws securely for each shaft from both ends
!IMPORTANT: DO
NOT
USE M10 X 1.5 X 25mm (1”) OR 35mm (1-3/8”) BOLTS IN SHAFTS
3/8 x 3/4
3/8 x 3/4
!IMPORTANT: DO
NOT
USE
M10 X 1.5 X 25mm(1”) OR
35mm(1-3/8”) BOLTS IN SHAFTS
NOTE: BENCH FRAME SHOULD BE
ORIENTATED SO THAT SLOTTED
HOLES FACE UPWARD AS SHOW
Содержание ADJUSTABLE BENCH
Страница 3: ...OVERHEAD VIEW 3...
Страница 5: ...EXPLODED VIEW 5...