Life Fitness 93Ci, Руководство по обслуживанию

Страница: 40 / 152

16
Lifecycle Upright Bikes LC95, LC91, LC85, C9, C7, 95Ce, 95Ci, 93Ci, and 90C
TEST/SERVICE - CSAFE NETWORK TEST
Within this state, the CSAFE network can be tested.
This is how you can check to see if you’re receiving any communications from the network system.
1. Remain in the CSAFE Test Mode above (by not exiting out of if).
2. Make sure the network cable is plugged in.
3. Press the COOLDOWN key. This will reset the console and send out the standard power up message to the
network. The console should display “RESETTING NETWORK”. The power up message sent to the network is
the same one the console sends every time it is turned on (or anytime it is used by a user on self-powered
products).
4. If the network has received the CSAFE communication packet from the console and the network sends
configuration communication packet to the console the console will display “RECEIVING…"
5. If the console has been properly configured by the network and is allowed to accept user ID’s then the console
would show “GETID MODE XX”. The “GETID” message means were in the get ID mode. This is the mode the
network must put the console in, before it will ask the user to enter in their ID’s. If the console is not put in this
mode then the console will not ask for ID’s.
6. If the network does not respond to the console then the console will display a “NOT CONNECTED” message.
This indicates there is a problem with the network cable or network itself. This means the console has not
received any valid CSAFE communications from the network.
Press the ENTER key to advance to the next diagnostic state. Press the CLEAR key to the previous diagnostic
state, or repeated pressing to exit diagnostics.