16
GSF2616JB
Owner’s Manual
LP (Propane) Gas Supply Connection
1. Always place the propane cylinder on the designated tank support area of the grill.
2. Always confirm that all burner control knobs are in the OFF position before activating the gas supply.
3. Before connection, be sure that there is no debris caught in the head of the gas cylinder, head of the regulator
valve, or in the head of the burner and burner ports.
4. Always connect the gas supply regulators as follows:
Insert the nipple of the valve coupling into the tank valve and tighten the connection
collar by turning it clockwise with one hand while holding the regulator with the other. (As
in the fig. shown on right)
5. Disconnect the propane cylinder from the regulator valve when the grill is not in use.
6. Do not obstruct the flow of combustion air and ventilation air to the grill.
DANGER
To prevent fire or explosion hazard when testing for a leak:
1. Always perform the “leak test “before lighting the grill and each time the cylinder is
connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use grill until all leaks have been stopped, if you are unable to stop a leak, disconnect the propane supply,
and call for gas appliance service or your local propane gas supplier.
Checking for Leaks
1. Make a 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.
2. Make sure control knobs are in the “OFF” position.
3. Spray some solution on all connections and hoses. (As the fig. shown on right).
4. Open the cylinder valve.
5. Inspect the solution, looking for bubbles. If no bubbles appear, the connections and
hoses are secure.
6. If bubbles appear, you have a leak. Go to step 7.
7. If bubbles appear on the hose, contact the customer service center and get a
replacement.
8. If bubbles appear at a connection point, disconnect and reconnect, making sure the
connection is secure.
9. Retest with solution.
10. If you continue to see bubbles, contact the customer service center.
Lighting Your Grill
Danger:
Failure to open lid while igniting the barbecue’s burners or not waiting 5 minutes to allow gas to clear if the
barbecue does not light ,may result in an explosion, which could cause serious bodily injury or death.
WARNING
: Never stand with your head directly over the grill when preparing to light the main burners, to prevent
possible bodily injury.
Main Burner
1. Open lid while lighting burners.
WARNING
: Attempting to light the burner with the lid closed may cause an explosion. Make sure there are no
obstructions of airflow to the gas unit. Spiders and insects can nest and clog the burner/venturi tube at the orifice. A
clogged burner tube can lead to a fire beneath the appliance.
2. All control knobs must be in the “OFF” position.
3. Open cylinder valve.
4. Ignite only the burners you wish to use, using the same method for each:
Automatic ignition: Push desired burner control knob and rotate slowly about 1/4 counter-clockwise until a click is
heard. Push button ignition: Push and turn desired burner control knob to the “High” position and then push the ignitor
button. The burner should light. If the burner does not light, return the control knob to the “OFF” position immediately.
Wait five minutes for the gas to clear and repeat the procedure. After burner is lit, repeat the procedure with any other
burner desired.
5. Adjust control knob(s) to desired cooking temperature.
