Lievers Prefab Easy Screed, Руководство по эксплуатации

Страница: 9 / 18

9/18
Operation Manual PREFAB EASY SCREED, revision 2: 29-6-2016
Fig. 5: Speed regulator
5.2. Use
1. Check that the profile is properly assembled and that the switch is in the OFF- position.
2. Place the machine in the direct vicinity of where you are going to finish the concrete.
3. Put the plug of the drive-unit’s feeder cable in the wall socket.
4. Place the machine on the surface of the freshly poured concrete, and turn the speed regulator slowly to the
required revolutions.
5. Now start to finish the surface.
6. After having finished one lane of concrete, switch of machine by turning the speed regulator’s knob to the
position –MIN-, You will hear a “CLICK”. Tip: If the processed concrete-surface is not smooth enough, repeat
the procedures 4, 5 and 6.
7. Pull the plug of the feeder cable out of the wall socket.
8. Clean the machine with water and a brush.
9. After use, place the Prefab Easy Screed on a dry and stable surface.