Liebert NX 10kVA, Руководство по установке

Страница: 50 / 68

Installation Drawings
44
7.0 I
NSTALLATION
D
RAWINGS
The diagrams in this section illustrate the key mechanical and electrical characteristics of the NX
UPS System cabinets.
Figure 23 Dimensional view- front and left side views
1. All dimensions are metric.
2. A minimum of 24 inches clearance above the unit is required for air exhaust.
3. Installation and service access required. Remove left plate. Left-side access recommended for maximum
ease of installation.
4. Keep cabinet within 15 degrees of vertical while handling.
5. Top and bottom cable entry available through removal access plates. Remove punch to suit conduit size
and replace.
6. Color - PMS 877.
7. Unit bottom is structurally adequate for forklift handling.
8. Open door to replace air filter, washable type, size 354x314.
9. Threaded mounting holes used for seismic anchoring or floor stand.
Note : If a floor stand is used, the
weight of the unit must be supported under all casters.
10. Each mounting location is supported by two 10 GA. (.135”) galvanized steel. The threaded 12mm insert
is approximately 3/4” deep. Mounting bolts must be threaded into unit.
11. Includes side panel. Refer to Detail A for dimension to frame with side panel removed. Side panels are
removed between adjacent units that are bolted together.
12. Leveling feet are not designed to carry the full weight of the cabinet. Finger-tighten leveler against the
floor, then tighten with a wrench less than two turns for friction against floor.
kVA
Rating
Voltage Weight Heat
Rejection
BTU/Hr
Cooling
Air CFM Input Output lb. kg
10 208 208 550 250 3422 324
15 208 208 550 250 4107 468
20 208 208 638 290 6844 540
30 208 208 682 310 8215 900
Monitoring
Panel
Air intake area.
Do not block
air filter.
FRONT VIEW LEFT SIDE VIEW
10mm dia. threaded
mounting holes
Detail “A” Rear of unit
shown without side panel
Leveling feet
(see Note 12)
825
600
1600
90
Leveler