Setup your controller
To setup your controller with correct IP- and ArtNet address connect your PC/ Mac to the ArtNetIn of the Controller.
The controller has P 192.168.0.98, Subnet 255.255.255.0, Gateway 192,168.0.1
After a reset on the controller by pressing the reset button, you also get back to this adress.
Reset your controller by disconnecting from power, press the RESET Button, switch on power again. Release RESET button after 2 seconds.
Open your browser window and type in the correct IP address to connect with your controller.
Once connected to your controller, you will see this page „Netzwerk“
In here, you can adjust IP address, subnet and gateway, as well as activate or deactivate DHCP (0=O
ff
, 1=On).
Manual | Controller Software
Bedienungsanleitung | Controller Software
„Netzwerk“ window