Operation Instruction
For additional protection the installation of residual current device (RCD) is advisable.
•
Remove all package material (including anti-vibration object of the lamp) and check the
appliance, supply cord and the plug for damage.
•
Pay attention to the mounting place and mounting material (dowels, screws). Ensure they are
suitable and stable enough for mounting and lastingly holding of the appliance.
•
Before mounting, the minimum distance and tilt angles shown in the figures must be strictly
followed.
•
The distance between the bottom edge of the appliance and the ceilings, roofs or other covers.
1.
There must be distance of at least 0.2 M between the appliance and the ceiling, roofs or other
covers.
2.
There must be a distance of at least 0.5 M at each side between the appliance and walls or the
like. See figure2.
3.
Remember that degree to mounting surface is 45°.
•
Pay attention that, the installation of the appliance must not add excessive wind load.
•
Fix the mounting bracket on the wall first. Ensure that the place to be installed is secure fix and
firm. Or connect the appliance to the stand.
•
The heaters are also widely used under parasol with the help of parasol brackets
•
Adjust the desired angle of radiation and fest screws. Check regularly the screws ‘connection.
Mechanical bearing pressure and oscillation due to wind or rain could lead to loose.
•
Plug in the source. Then observe, whether during the 10-15 minutes the appliance works
trouble-free.
