LED area, site and roadway luminaire
LTOK Series Installa�on Instruc�ons
U Bracket moun�ng
Note: Adjustable angle is 0-180°
1. Use expansion bolts (not included) to secure the fixture on moun�ng surface.
2. Keep enough length on the wires to ensure fixture can be adjusted to desired
angle unhindered.
3. Make wire connec�ons. Refer to wire diagram for power connec�ons..
4. Ajust the fixture to desired angle and �ghten the screws on the side of fixture
to secure.
IMPORTANT
D
o not a�empt to service the LED driver for reduce the risk of electric shock. The use of accessory equipment may
cause an unsafe condi�on. Do not use this product for other than intended use. Refer any servicing indicated by
these checks to a Qualified Service Personnel.
TROUBLESHOOTING
1
. Check that the line voltage at fixture is correct. Refer to wiring direc�ons.
2. Be sure the fixture is grounded properly.
CLEANING
C
AUTION: Be sure fixture temperature is co ol enough to touch. Do not clean or maintain while fixture is energized.
1
. Lens should be washed in a solu�on of warm water and any mild, non abrasive household detergent, rinsed with
clean water and wiped dry. Do not use chemicals to clean fixture.
2
. Do not open fixture to clean the LED. Do not touch the LED.
368mm [14 1/2"]
Ă12.5mm
[Ă1/2"]
40mm [1 5/8"]
210mm [8 1/4"]
40mm [1 5/8"]
11mm [3/8"]
Adjustable
0-180°
