LED Outdoor Security Light
LT-ALP-20W-MA Installa�on Instruc�ons
③
Rotatable
Rotatable
6) To adjust the sensor device and
to set the head of lamp to suitable
posi�on.
Note:
These instructions do not cover all details or variations in equipment nor do they provide for every
possible situation during installation, operation or maintenance.
②
3) To paste the EVA Gasket onto the surface of Junc�on Box.
4)
To connect three lead wires of this lamp to the lead wires of Junc�on Box correspondingly with 3pcs of
wire Connec�ng Caps and no�ce to keep good grounding connec�on.
5) To secure this lamp to the Junc�on Box with the screws by passing the screws through the center hole
of this lamp fixture, and then finish the installa�on.
IMPORTANT
D
o not a�empt to service the LED driver for reduce the risk of electric shock. The use of accessory equipment may
cause an unsafe condi�on. Do not use this product for other than intended use. Refer any servicing indicated by
these checks to a Qualified Service Personnel.
TROUBLESHOOTING
1
. Check that the line voltage at fixture is correct. Refer to wiring direc�ons.
2. Be sure the fixture is grounded properly.
CLEANING
CAUTION: Be sure fixture temperature is co ol enough to touch. Do not clean or maintain while fixture is energized.
1
. Lens should be washed in a solu�on of warm water and any mild, non abrasive household detergent, rinsed with
clean water and wiped dry. Do not use chemicals to clean fixture.
2
. Do not open fixture to clean the LED. Do not touch the LED.
