Making measurements
If you want to store a second calibration multiplier (either
for a second sensor or the
In Water
and
In Air
multipliers
for the LI-192 and LI-193 Underwater Quantum Sensors)
press
CAL
, then press
MULT SELECT
to switch to the second
multiplier. Press the arrow key to change the value of the
multiplier, and then press
CAL
to save it.
The multiplier in
effect is the one displayed when you press
CAL
to exit con-
figuration mode.
Note:
Pressing
MULT SELECT
before pressing
CAL
dis-
cards any changes you have made to the multiplier cur-
rently shown on the display.
Pressing
CAL
when in measurement mode will display the
multiplier in current use. The multiplier displayed when
CAL
is pressed again will be stored as the active multiplier,
whether you have changed it or not.
While in measurement mode, press
HOLD
to retain the cur-
rent reading on the display. Press
HOLD
again to restore
live readings. Press
AVG
to begin a 15 second average,
which will be displayed until you press the
HOLD
key to
resume measurements. Press and release the
OFF
button to
power off the LI-250A. It will automatically shut off after
25 minutes of inactivity in measurement mode.
Caution:
The LI-250A is weather resistant. However,
protect the meter from immersion or prolonged contact
with water, especially in marine environments. Water
damage is not covered under the warranty.
3
