LI-COR AirLink RV50X, Инструкция по эксплуатации

Страница: 58 / 90

Section 5. Connecting with remote instruments
Connecting to a LI-COR Biomet Data Acquisition System
To connect with the LI-COR data acquisition system with the Blueprint Utility:
1
On an internet-connected computer, launch the Blueprint Utility.
2 Enter the IP address for the RV50X that hosts the Data Acquisition System.
3
Click
Connect
.
You may need to set the serial port.
Connecting to the PhenoCam
To connect directly to the PhenoCam:
1 Open a web browser.
2 Type the RV50X IP address into the address bar, followed by a colon and the Private Start Port.
It will take a format similar to this: xxx.xxx.xxx.xxx:7980
3 Press
Enter
to connect.
Connecting to the biomet system (Sutron logger)
This section describes how to connect with the Biomet System (Sutron logger)
from a computer with Internet access. You will find this useful if you want to
retrieve data, review the performance of the system, or alter the configuration. You
will need to open port 23 on the RV50X, as described in
Configuring the RV50X on
page 4-1).
1 On a computer that has Internet access, launch the Sutron XTerm configuration software.
2 Select
TELNET
from the
Hardware
field, then enter the RV50X
IP address
as the URL. Click
OK
.
l
If the RV50X has a
Static IP
address, simply type it in (see Static IP address on
page A-5).
l
If the RV50X has a
Dynamic IP
address, retrieve the IP address from the DDNS
service provider (see Dynamic IP address on page A-5) and type it in.
5-6 AirLink Cellular Communication