LHZ Radiator, Руководство пользователя

Страница: 16 / 19

Troubleshooting
The room is getting too hot.
Manual radiator:
Reduce the temperature by turning the dial to a lower number.
Wireless Control:
Reduce the temperature by putting the controller into the sun setting and
pressing the minus button.
Make sure the controller is linked to the receiver, if the green light on the
radiator is blinking, then you need to perform the initial setup.
Make sure the radiator is not in manual mode, if the yellow light on the
radiator is showing, press the button on the radiator receiver until the
yellow light is no longer showing.
Make sure that the controller is in a position where it can measure the
temperature of the room (in the same room as a radiator), and between 1m
and 1.5m from the floor.
The radiator is coming on when it shouldn’t.
Manual radiator:
Turn the radiator off at the wall plug.
Wireless control:
Move the controller to the moon setting and reduce the temperature of the
moon setting down to 5 degrees, by pressing the minus button.
The radiator is not heating the room sufficiently.
Manual radiator:
Turn the dial up slightly until the red light shines. However, make sure
the radiator still cycles on the thermostat (light goes out regularly).
Wireless control:
Put the controller in the sun setting and increase the temperature by one or
two degrees.
Make sure the controller is linked to the receiver, if the green light on the
radiator is blinking, then you need to perform the initial setup.
Make sure the radiator is not in manual mode, if the yellow light on the
radiator is showing, press the button on the radiator receiver until the
yellow light is no longer showing.
Make sure that the controller is in a position where it can measure the
temperature of the room (in the same room as a radiator), and between 1m
and 1.5m from the floor.