LGMG T65J, Руководство по обслуживанию

Страница: 13 / 38

LGMG North America Inc. Maintenance Manual
7
damage to the engine. The engine oil level can
only be checked when the engine is placed
horizontally and closed. If the engine is hot,
close the engine and check the engine oil level
5 minutes later. Check it immediately if the
engine is cooled.
1) Insert the oil measuring rod and clean it
with a piece of clean and fiber-free cloth.
2)
Insert the oil measuring rod into the bottom.
3) Pull out the oil measuring rod and read the
value of engine oil level.
4)
The engine oil level shall always be
between MIN and MAX!
Fill up to the maximum liquid level if necessary.
1.8 Replacement of Engine
Oil and Filter
△
!
Do not operate on running
engines! No smoking and open fires!
Be careful when contacting with high
temperature engine oil. Danger of
scalding!
△
!
When operating on the oil system,
pay attention to the surface cleaning.
Carefully clean all areas involved. Blow
wet parts with compressed air.
△
! Please observe the safety
regulations for engine oil and relevant
local regulations. Dispose of spilled
engine oil and filter elements as
required. Waste oil cannot penetrate
into the ground.
△
! Test run shall be carried out after
each operation. At the same time, pay
attention to the sealing and lubrication
oil pressure, and then check the
engine oil level.
It is available in the first 50 hours, and the
engine oil and filter shall be replaced every 500
hours. (If the ambient temperature continues to
be below -10
℃
. (14
゜
F) or the temperature of
engine oil is below 60
℃
(84
゜
F), or the sulphur
content in the diesel fuel is 0.5 - 1%, the oil
change period is reduced by a half; if the engine
oil does not reach the replacement interval
period within a year, the oil shall be replaced at
least once a year.)
△
!
Danger of burn, be careful of
high-temperature engine parts and oil,
contacting with high temperature
engine oil and/or engine parts will
cause severe burns.
△
!
Perform the function after engine
warm up to normal operation
temperature.
Replacement of engine oil
△
! After the filter element is replaced,
be sure to keep the engine idling at a
low speed for at least 3-5 minutes, so
that the engine has been lubricated
before being put into operation.
Figure 1-6
1) Warm up and run the engine (engine oil