LGMG T20J, Руководство по обслуживанию

Страница: 24 / 35

Maintenance Manual of Elevating Work Platform
18
1.20 Engine fault Codes
KWP-Code SPN FMI
Error Identification
45 168 3
Battery voltage: The voltage measured by ECU is out of the target
range, system reaction is initiated.
46 168 4
Battery voltage: The voltage measured by ECU is out of the target
range, system reaction is initiated.
47 168 2
Battery voltage: The voltage measured by ECU is out of the target
range,system reaction is initiated.
84 639 14
CAN bus 0: The ECU is not allowed to send messages because the
status "BusOff" is detected.
85 1231 14
CAN-Bus 1: The ECU is not allowed to send messages, because
the status "BusOff" is detected.
Warning, no diagnostic with SERDIA2010 is possible.
88 102 2
Charge air pressure measured by sensor is above the warning
threshold.
89 102 2
Charge air pressure measured by sensor is above shut off
threshold.
92 110 0
Coolant temperature sensor: The voltage of the sensor measured
by ECU is out of the target range
93 110 1
Coolant temperature sensor: The voltage of the sensor measured
by ECU is out of the target range.
96 110 3
Coolant temperature sensor: The voltage of the sensor measured
by ECU is out of the target range (Signal range check high).
97 110 4
Coolant temperature sensor: The voltage of the sensor measured
by ECU is out of the target range (signal range check low).
98 110 0
Coolant temperature: The coolant temperature calculated by ECU
is above the target range; The ECU activates a system reaction.
99 110 0
Coolant temperature: The coolant temperature calculated by ECU
is above the target range.
The ECU activates a system reaction.
101 111 1
Coolant level: The coolant level calculated by ECU is below the
allowed minimum
126 523603 9
Timeout Error of CAN-receive-frame AMB; Ambient temperature
sensor
171 523212 9
Timeout error of CAN-Receive-Frame ComEngPrt.
Engine Protection.
179 523240 9
Timeout CAN-message FunModCtl.
Function Mode Control.
291 523776 9
Timeout error of CAN-Receive-Frame TSC1TE - active
292 523777 9
Passive timeout error of CAN-Receive-Frame TSC1TE.
Setpoint
305 898 9
Timeout error of CAN-Receive-Frame TSC1TE.
Setpoint
360 523982 0
Powerstage diagnosis disabled.
High battery voltage.
361 523982 1
Powerstage diagnosis disabled.
Low battery voltage
362 523090 2
When any of the switch inputs is not active for a period of time.
376 630 12
Internal hardware monitoring, the ECU finds an error during the
access to its EEPROM memory or works with an alternative value
377 630 12
Internal hardware monitoring: The ECU finds an error during the
access to its EEPROM memory or works with an alternative value