LGMG AS1932E, Руководство по эксплуатации и безопасности

Страница: 30 / 68

LGMG North America Inc.
Operation and Safety Manual
22
6.12 Driving Function Test
1) Press the lift function button; the
indicator lamp will light up. Press and hold
the enable switch to lift the platform to the
height called out in the following table. Result:
The pothole guards will be deployed.
Table 5 - Pothole Deployment Height When Driving
Model Height
AS1932E
6.9ft (2.1m)
AS3246E
AS2646E
SS1230E
6.56ft (2m)
2) Press the drive function selector button. The
indicator light will light up.
3) Press the enable switch on the control handle
and slowly move the control handle fully
forward. Result: The drive speed of the
platform will not be greater than 0.5mph
(0.8km/h) when the platform is elevated. On
model SS1230E, the driving speed of the
platform is 0.3mph (0.5km/h) when the
platform is elevated. If the elevated driving
speed of the platform exceeds these limits,
immediately tag out the controls and stop
operation until repairs are made.
6.13 Operation of Tilt Sensor
Test
△
! Notice
This test is performed with the platform
controller from the ground. Do not stand
in the platform.
1) Completely lower the platform.
2) Drive two wheels on the same side of the
machine up on a 1.37×7.9in (3.5×20cm)
block.
3) Lift up the platform to a height listed in the
following table. Result: The platform will stop
moving and the tilt alarm will sound at a rate
of 120 times per minute.
Table 6- Drive Cutout Height When Tilted
Model Height
AS1932E 5.6ft (1.7m)
SS1230E
6.56ft (2m)
AS3246E
6.9ft (2.1m)
AS2646E
8.53ft (2.6m)
4) Slowly move the control handle to operate
drive forward and then driver reverse. Result:
The drive function will be disabled in either
direction.
5) Lower the platform and drive the machine off
of the blocks.