LGB 20061, Инструкция по эксплуатации

Страница: 6 / 17

5
Safety Notes
• This model may only be used with the operating system designed for it.
• Use only switched mode power supply units and transformers that are designed
for your local power system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.
• The LEDs in this item correspond to Laser Class 1 according to Standard EN 60825-1.
Important Notes
• The operating instructions are a component part of the product and must therefore
be kept in a safe place as well as included with the product, if the latter is given to
someone else.
• Please see your authorized LGB dealer for repairs or spare parts.
• The warranty card included with this product specifies the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
• The LEDs in this item correspond to Laser Class 1 according to Standard EN 60825-1.
Functions
• This model is designed for operation on LGB two-rail DC systems with conventio -
nal LGB DC train controllers or power packs (DC, 0 - 24 volts).
• Interface connector for installation of a decoder (E275227).
• Lighting by means of maintenance-free LEDs.
• The following functions are available with the built-in decoder:
F1: Headlights
F2: Interior lights
F3: Interior lights
F4: ABV, off
F5: Low speed switching range
Note: Use a locomotive controller with more than 1 amp of train current for this model.
The couplers mounted on the model can be replaced by „link-and-pin“ couplers
(American-style link-and-pin coupler, 64777) (Figure 2).
Mode of Operation Switch
This model has a 4-position mode of operation switch on the underside (Figure 1).
Pos. 0 Locomotive stored without current
Pos. 1 Lighting turned on
Pos. 2 Lighting turned on
Pos. 3 Locomotive motor and lighting turned on
Multi-Train System
This model has a direct decoder interface. For Multi-Train System operation. Remove
the plug on the decoder interface and connect the decoder.
We recommend to have the decoder mounted by the LGB factory service station.
Recommended decoder: E275227. The standard H0 decoders are unsuitable due to the
high current draw on this model.
When a decoder is integrated in the locomotive, the power control switch ist obsolete.
SERVICE
Lubrication
The axle bearings should be lubricated occasionally with a small amount of Märklin-
Oil (7149).