LG WTG9020MB, Руководство пользователя

Страница: 8 / 40

8 SAFETY INSTRUCTIONS EN
• Make sure that drainage is working properly. If water is not drained
properly, your floor may get flooded.
• If, during spinning, opening the door does not stop the drum within
about 10 seconds, immediately discontinue operating the appliance
and contact your dealer or LG Electronics service centre.
• When the air temperature is high and the water temperature is low,
condensation may occur and thus wet the floor.
• Wipe off dirt or dust on the contacts of the power plug.
• Under certain conditions hydrogen gas may be produced in a water
heater that has not been used for two weeks or more. Hydrogen gas
can be explosive under these circumstances. If the HOT water has not
been used for two weeks or more, prevent the possibility of damage
or injury by turning on all Hot water taps and allowing them to run for
several minutes. Do this before using any electrical appliance which
is connected to the HOT water system. This simple procedure will
allow any built-up hydrogen gas to escape. Since the gas is
flammable, do not smoke or use an open flame or appliance during
this process.
Maintenance
• Remove the power plug when you clean the appliance.
• Securely plug the power plug in the outlet socket after completely
removing any moisture and dust.
• Do not spray water inside or outside the appliance to clean it.
• Never unplug the appliance by pulling on the power cable. Always
grip the power plug firmly and pull straight out from the outlet
socket.
• Only qualified service personnel from LG Electronics service centre
should disassemble, repair, or modify the appliance. Contact an LG
Electronics customer information centre if you move and install the
appliance in a different location.