![LG WT-R107 Скачать руководство пользователя страница 29](http://html.mh-extra.com/html/lg/wt-r107/wt-r107_owners-manual_222312029.webp)
28
Installation
C
onnecting Water Supply Hose
Normal Type (Normal tap without thread & one touch type inlet hose.)
1
2
3
4
5
6
Note
Separate Middle connector from Water Supply Hose
Separate Middle connector from the Water Supply Hose by
pulling the Pressing Rod and the Pressing Handlre that is
attached to the Water Supply Hose.
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Middle
Connector
Loosen the fixed nuts to connect the connector to the tap
Untighten the screw of the connector so that the tap can be
placed in middle.
In case tap is too large.
If the tap diameter is too large or is square, untighten
the 4 screws and remove the guide plate. Then follow step1.
Rubber packing
Fixed sticker
screw
Rubber packing
Guide plate
Fixing Connectors to the Tap
Push the upper connector up till the rubber packing is in
tight contact with the tap. Then tighten the 4 screws.
Connector
Fixing Upper Connector and Middle Connector
Remove the fixed sticker in between the Upper and Middle
Connectors. Tighten the connectors by holding one
connector and twist middle connector to the right.
Connector
Fixed sticker
Middle
Connector
Middle
Connector
Connector
Connecting Middle Connector and water Supply Hose
Press down the pressing rod of the Water Supply Hose
whick was separated from middle connector
(refer to Step 1) and then join it to the middle connector.
Water Supply Hose
Pressing rod
Pressing handle
Check for water leakage
After connecting the hose, open the tap to check for any water
leakage.
If the connection leaks, close the tap and start again from step 1.
If you skip step 1, water leakage may occur.
Содержание WT-R107
Страница 1: ...P No MFL30138474 ...