Interim spin rinse prior to regular rinsing helps removing sudsy water from the
laundry and improve rinsing efficiency. Also is helpful to water saving.
HOW TO RINSE & HOW TO SPIN
INSTALLATION
Installation area
Connecting the earth wire
Connecting the power plug
Voltage Change
(only for dual voltage)
Maintain more than 10 cm between
the side of drain hose and the wall.
A carpet must not obstruct the
ventilation openings.
INSTALLATION & HOW TO WASH
Before washing
1. Check the washing instruction labels on the clothing to be washed.
2. Remove all objects from the pockets of the clothing.Objects left in the pockets may
damage clothing or the washing machine (could cause the drain hose to clog).
3. After separating oiled or dyed clothing, wash.
4. For your convenience hang up the wash cover on the right or left side of the
washing machine tub when not in use.
r
1
2
After washing.
Move the laundry into
the spin dryer basket.
Place the safety cover
horizontally on the
laundry.
After interim spin
rinse, move the
laundry into the
wash tub for rinsing.
Set the water
selector to "SPIN".
3
Set the desired
spin flow
1.
3.
dryer basket.
2. Put the laundry down lightly.
Place the safety cover horizontally
over the laundry.
4. Close the spin dryer cover.
If the spin dryer basket is off-balance and vibrates excessively, stop the
spinning, rearrange the clothes evenly, and then resume spinning.
Safety cover
●
●
●
Set on flat and firm floor.
Incorrect installation may course
●
●
Install the earth wire to prevent short-circuit due to leaking current and electric shock.
●
It is attached at the back of the washer.
Connect it to the metal water pipe.
●
Do not connect the earth wire to the
gas pipe, lightning arrester. telephone
connecter, etc.
Gas pipe
Earth
wire
●
Insert the power plug into the outlet.
●
●
●
Before connecting the power plug, check if the voltage
setting of the washer matches the out let voltage.
If AC outlet with ground terminal is used, grounding is not
needed. If not, never forget earthing (Refer earthing method above).
4
5
6
Other earthing method
Earth
wire
●
After connecting the earth
wire to the earth copper
plate, bury it at least 75cm
deep under the wet
ground.
●
Connect to the
earthing-only outlet.
●
When installing it in an
area where earthing is
not possible, purchase a
short-circuit breaker
connect it to the outlet.
Earth copper plate
Earth
wire
75cm
Short-circuit breaker
Note for spinning
How to wash
The appliance must be positioned so that the plug is accessible.
Warning-the appliance with two-pronged plug must be grounded.
If the water pipe is made of plastic,
This washer is assembled for 220V, but can be changed from
220V to 110V(or 127V).
Check your electrical source and follow the diagram below
to convert voltage.
laundry.
Set the desired
spin time
with the
6
3
2
For Non-Pump Model
4
Put the appropriate amount
of detergent and the laundry
into the wash
tub. And add
Set the desired wash
time.
7
When washing is finished,
locate the drain selector to
"DRAIN" position and drain
the water out.
8
Spinning in the spin
dryer basket.
Move the laundry into
the spin dryer basket.
Put the laundry down
lightly.
Place the safety cover
horizontally on the
Set the water selector
to "WASH"
WASH
Water Selector
For Pump Model
5
Select the wash
program to "GENTLE",
"NORMAL" or
"STRONG" according
to the kinds and
quantity of the laundry.
(Refer to Tabel 2)
water to the
desired water
level which
you want.
spin timer.
severe noise and break down.
it does not have the earth effect.
Inter spin rinse
Water Selector
SPIN
appropriately.
Put the laundry evenly into the spin
4
1
For Non-Pump Model
For Pump Model
Set the drain selector
Set as
"OFF"
position.
Set as
"WASH RINSE"
position.
Open the water tap and
fill water in the wash tub
about halfway
to the desired
water level.
TROUBLESHOOTING GUIDE
Problem
Checking point
Motor does not operate,
Is the power cord firmly plugged in?
Is the timer turned to a suitable point except "OFF" ?
Spin dryer basket does
Is there any clothing dropped between the basket and tub?
not operate.
Is the spin dryer cover closed?
Is the laundry gathered to one side of the spin dryer basket?
No draining
For Non-Pump Model
Is there lint stuck in the plunger valve?
Is the end of the drain hose guide located at an exceed height?
Is the drain pump operated?
Before Requesting Service
For Pump Model
TABLE 1. WEIGHT GUIDE FOR CLOTHES
Type of clothing
Type of fabric
Weight per piece
Under shirt
Cotton
150g(53oz)
Handkerchief
Cotton
50g(1.8oz)
Bath towel
Cotton
300g(10.6oz)
Shirt
Mixed fabric
200g(7.1oz)
Socks (1 pair)
Mixed fabric
50g(1.8oz)
Pajama (shirt and pants)
Cotton
500g(17.6oz)
Winter undershirt
Cotton
600g(21.2oz)
Workclothes
Mixed fabric
800g(28.2oz)
Blouse
Mixed fabric
200g(7.1oz)
REFERENCE
7
Amount of laundry is based on dry laundry.
Detergent amount is based on a general synthetic detergent.
TABLE 2.
GUIDE FOR WASHING
L
50
4.5 ~ 5.5
M
58
5.5 ~ 6.5
H
67
48 ~ 52
S
43
0.5 ~ 4.5
40 ~ 45
56 ~ 60
65 ~ 70
50
58
67
48 ~ 52
43
40 ~ 45
56 ~ 60
65 ~ 70
50
58
67
48 ~ 52
43
40 ~ 45
56 ~ 60
65 ~ 70
6.5 ~
L
4.5 ~ 5.5
M
5.5 ~ 6.5
H
S
0.5 ~ 4.5
6.5 ~
L
4.5 ~ 5.5
M
5.5 ~ 6.5
H
S
0.5 ~ 4.5
6.5 ~
Type of
fabric
Synthetics,
Silk, Woolen,
Knits
GENTLE
NORMAL
STRONG
Very soiled
cotton and
linen
Cotton,
Linen
Wash
Selector
Wash
time
Water
level
Amount of
laundry (Kg)
Amount of
detergent (g)
Amount of
water ( )
min
min
min
If washing and spinning mest be operated together, starting washing and spinning
operation shall be done at the same time to cope with EMC requirement.
CARE
Overflow filter & Rotation filter-C
1.
Take out the rotation filter-C by pulling in the direction shown.
2.
Turn the net over and rinse in water.
3. After cleaning, replace the rotation filter-C.
6.
Insert the over flow filter back into the wash tub.
4. Pull the overflow filter forward from the wash tub in the direction of the arrow.
the overflow filter.
5.
Use a brush or your hand to remove all of the lints whichs has adhered to
1
2
3
4
5
6
