13
7. TROUBLE SHOOTING
7-1. BEFORE PERFORMING SERVICE
Be careful of electric shock when disconnecting parts while troubleshooting.
The voltage of each terminal is 110/120 V AC and DC when the unit is plugged in.
7-2. QC TEST MODE.
The washer must be empty and the controls must be in the off state.
1. Press the
Stain Cycle
and
Soak buttons
simultaneously.
2. Press the Power button, while the above condition. Then buzzer will sound twice.
3. Press the Start/Pause button repeatedly to cycle through the test modes.
7-3. HOW TO CHECK THE WATER LEVEL FREQUENCY
Press the
Quick Cycle
and
Spin Speed button
simultaneously.
So, for example a display indicating 241: a Water level frequency of 241 x.1 kHz
= 24.1 kHz
The digits indicate the water level frequency ( x.1 kHz ).
Check Point
Display Status
None
Turns on all lamps and locks the door.
1 time
Tumble counterclockwise
rpm (40~50)
2 times
Low speed Spin.
rpm
3 times
High speed Spin.
rpm
4 times
Inlet valve for bleach turns on.
Water level frequency (25~65)
5 times
Inlet valve for main water turns on.
Water level frequency (25~65)
6 times
Inlet valve for hot wash turns on.
Water level frequency (25~65)
7 times
Tumble clockwise
rpm (40~50)
8 times
Heater turns on for 3 sec.
Water temperature
9 times
Drain pump turns on.
Water level frequency (25~65)
10 times
Power off.
Turn off all lamps.
Number of times the
Start/Pause button is pressed
