28
Install
ation
C
onnecting Water Supply hose
1
Separate Middle connector from Water Supply Hose.
Separate Middle connector from the Water Supply
Hose by pulling the Pressing Rod and the Pressing
Handle that is attached to the Water supply Hose.
2
Loosen the fixed nuts to connect the connector to the tap.
Untighten the screw of the connector so that the
tap can be placed in the middle.
3
Fixing Connectors to the Tap.
Push the upper connector up till the rubber packing
is in tight contact with the tap. Then tighten the 4
screws.
4
Fixing Upper Connector and Middle Connector.
Remove the fixed sticker in between the Upper and
Middle Connectors.
Tighten the connectors by holding one connector
and twist middle connector to the right.
5
Connecting Middle Connector and Water Supply Hose.
Press down the pressing rod of the Water Supply Hose
which was separated from middle connector (refer
to Step 1) and then join it to the middle connector.
6
Check for water leakage.
After connecting the hose , open the tap to check
for any water leakage.
If the connection leaks, close the tap and start again
from step 1.
If you skip step 1, water leakage may occur.
Normal Type
(Normal tap without thread & one touch type inlet hose.)
NOTE
In case tap is too large.
If the tap diameter is too large or is square, untighten the
4 screws and remove the guide plate. Then follow step 1.
Water Supply hose
Middle
connector
Pressing Rod
Pressing handle
Fixed Sticker
Rubber packing
Rubber packing
Connector
Connector
Connector
Middle
Connector
Middle
Connector
Guide plate
screw
Fixed Sticker
Fixed Sticker
Pressing
handle
Pressing rod
Water Supply hose
Содержание WF-S100DB
