LG RH16U8 VCW Series, Руководство пользователя

Страница: 12 / 48

12
INSTALLATION
Installation Location
Requirements
Before installing the appliance, check the following
information to make sure that the appliance is
installed in the correct location.
Installation Location
WARNING
• Do not install the appliance around a heat
source. The rear side of the appliance must be
well ventilated. Failure to follow these
instructions may result in problems.
• The appliance is not designed for maritime use
or for use in mobile installation such as caravans,
aircraft and etc.
• Do not install the appliance as a built-in
appliance. It is not suitable for built-in purpose.
NOTE
• For better drying performance, keep the rear of
the appliance away from the wall.
• Make sure that the location where the appliance
will be installed meets a minimum clearance
conditions.
• Install the appliance on a flat hard floor.
Allowable slope under the appliance is 1 degree.
• Never try to correct any unevenness in the floor
with pieces of wood, cardboard or similar
materials under the appliance.
• Install the appliance in a location where service
engineers are easily accessible in the event of a
breakdown.
• Do not install the appliance next to high-
temperature appliances such as refrigerator,
oven or stove, and etc. It can cause poor drying
performance and delay programme duration. It
also adversely affect the proper functioning of
the compressor.
• Do not install the appliance where there is a risk
of frost or dust. The appliance may not be able to
operate properly or may be damaged by
freezing of condensed water in the pump and
drain hose.
• With the appliance installed, adjust all four feet
using a spanner to ensure the appliance is
stable, and a clearance of approximately 20 mm
is left between the top of the appliance and the
underside of any work-top.
Ventilation
• Alcove or under counter
- Make sure that air circulation around the
appliance should not be impeded by carpets,
rugs, etc.
• Cupboard
- Cupboard door must have 2 (louvered)
opening, each have a minimum area of 387
cm
2
, located 8 cm from bottom and top of the
door.
Ambient Temperature
• Do not install the appliance in rooms where
freezing temperatures may occur. Frozen hoses
may burst under pressure. The reliability of the
electronic control unit may be impaired at
temperatures below freezing point.
NOTE
• If the appliance is delivered in winter and
temperatures are below freezing, place the
appliance at room temperature for a few hours
before putting it into operation.
A 100 mm
B 20 mm
A B B