31
EN
Emptying the Water Container
Condensed water is collected in the water
container.
Empty the water container after every use. Not
doing so will affect the drying performance.
If the water container is full, the
icon glows
and the buzzer sounds while the appliance is
operating. If this should occur, the water
container needs to be emptied within the next
hour.
1
Pull out the water container.
2
Empty the water container in the sink.
3
Push it back into the appliance.
4
Press the
Start/Pause
button.
Cleaning the Cool Air Inlet
Grill
Vacuum the Cool Air Inlet grill 3 – 4 times a
year to make sure there is no build up of lint or
dirt that may cause improper air flow.
NOTE
•
Warm air is exhausted through the ventilation
grill.
•
Adequate ventilation should be provided to
avoid the back flow of gases into the room
from units burning other fuels, such as open
fires.
Wiping the Moisture Sensor
This device senses the moisture level of the
laundry during operation, which means it must
be cleaned regularly to remove any build up of
lime scale on the surface of the sensor.
Wipe the sensors inside the drum.
CAUTION
•
Do not wipe the moisture sensor with abrasive
materials. Always clean the sensor with a
rough sponge.
Содержание RC8 U2 Series
