10
ENGLISH
(For installation on wood stud)
Use the Ø 4 mm drill bit for wood to drill holes with the depth of
76 mm. (Clean the drilled hole.)
Drywall
Wood stud
76 mm
Without using the wall mounting anchor, fasten the wall mounting
screw directly to the wood stud.
After Installation
•
When connecting additional cables from the sides, we
recommend holding the centre of the TV horizontally or
vertically and pulling the product to make sure there is
sufficient distance from the wall before connecting.
•
When connecting additional cables from the bottom, we
recommend releasing the TV from the wall mount before
connecting.
•
Use cable management systems to arrange the
cables at the bottom of the TV as shown below. Cable
managements are not provided with the product, so
purchase them separately.
(For example)
•
After installing the product, be sure to use it adhered to
the wall.
-
Using the product while it is not adhered to the wall
may damage or shake the product.
Connections
Connect various external devices to the TV and switch input modes to
select an external device. For more information of external device’s
connection, refer to the manual provided with each device.
Antenna/Cable
Connect the TV to a wall antenna socket with an RF cable (75 Ω).
•
Use a signal splitter to use more than 2 TVs.
•
If the image quality is poor, install a signal amplifier properly to
improve the image quality.
•
If the image quality is poor with an antenna connected, try to
realign the antenna in the correct direction.
•
An antenna cable and converter are not supplied.
•
This TV cannot receive ULTRA HD (3840 x 2160 pixels) broadcasts
directly because the related standards have not been confirmed.
Other connections
Connect your TV to external devices. For the best picture and audio
quality, connect the external device and the TV with the HDMI cable.
Some separate cable is not provided.
HDMI
•
When connecting the HDMI cable, the product and external devices
should be turned off and unplugged.
•
Supported HDMI Audio format (Depending on model):
True HD (48 kHz),
Dolby Digital / Dolby Digital Plus (32 kHz / 44.1 kHz / 48 kHz),
PCM (32 kHz / 44.1 kHz / 48 kHz / 96 kHz / 192 kHz)
•
→
→
[Picture]
→
[Additional Settings]
→
[HDMI Ultra
HD Deep Colour]
-
On: Support 4K @ 50/60 Hz (4:4:4, 4:2:2, 4:2:0),
4K @ 100/120 Hz (4:4:4, 4:2:2, 4:2:0)
-
Off: Support 4K @ 50/60 Hz (4:2:0)
If the device connected to Input Port also supports Ultra HD Deep
Colour, your picture may be clearer. However, if the device doesn’t
support it, it may not work properly. In that case, change the TV’s
[HDMI Ultra HD Deep Colour] setting to Off.
