PREP
ARA
TION
11
Before Operation
Setting the Clock
11
Press CLOCK.
(If the clock requires setting, press and hold CLOCK
for more than 2 seconds.)
- The hours display begins to blink.
22
.
Select either the 12 hour cycle or the 24 hour
cycle by turning MULTI JOG..
33
Press SET/CD
[]
to confirm the selected hour
cycle.
44
Use MULTI JOG. to set the current hour.
55
Press SET/CD
[]
.
66
.
Use MULTI JOG. to set current minutes.
77
Press SET/CD
[]
and the correct time is shown
on the display.
Notes
Notes
When the clock is not appeared in the display
window, follow as below.
- In case the clock is set, prese the CLOCK button.
The clock will be shown in the display window for
about 5 seconds.
- In case the clock is not set, the clock will be blinked in
the display window for about 1 minute. Set the clock
as above.
Sleep Timer Function
When the sleep timer is set, the unit automatically turns
off after the specified time has elapsed.
11
To specify the time delay before the power is
turned off, press SLEEP.
In the display window you can see SLEEP 180 for
about 5 seconds. This means that the system turns
off automatically after 180 minutes.
22
Each time you press SLEEP the setting changes
in the following order.
SLEEP 180
→
150
→
120
→
90
→
80
→
70
→
60
→
50
→
40
→
30
→
20
→
10
→
OFF (No display)
→
SLEEP 180...
33
To check the remaining time until the power is
turned off.
While the sleep function is active press SLEEP
briefly. The time remaining until the unit turns off is
displayed for about 5 seconds.
Note
Note
If you press SLEEP while the sleep time is displayed,
the SLEEP time is reset.
To cancel Sleep Timer setting
If you wish to stop the function, press the SLEEP button
repeatedly until “SLEEP 10 ” appears, and then press
SLEEP once again after “SLEEP 10 ” shows on the
display.
Using Microphone - OPTIONAL
You can sing to a music source by connecting a
microphone to the unit.
1
Connect your microphone to the MIC1/ MIC 2
Jacks.
“
” will be shown in the display window.
22
Play a music you want.
33
Sing along with the accompaniment.
Adjust the microphone volume by turning MIC
VOL. knob. (MIN,1 - 14, MAX steps)
For your reference
You can record during using microphone.
Refer to the “Recording” explanation section.
Notes
Notes
• When not using the microphone, set the MIC
VOL.volume knob to minimum or turn off the MICs
and remove the microphone from the MIC Jacks.
• If the microphone is set too near the speaker, a
howling sound may be produced. In this case, move
the microphone away from the speaker or decrease
the sound level by using the MIC VOL.volume con-
trol.
• If sound through the microphone is extremely loud, it
may be distorted. In this case, turn the MIC VOL.
volume control toward minimum.
To Adjust ECHO Volume
You can give an echo effect to the sound from the
microphones.
Press the ECHO VOL. (
/
) on the remote control to
increase the echo volume or decrease it.
(MIN,1 - 14, MAX steps)
(12HR)
(24HR)
or
