LG LTNC182QLE0, Руководство пользователя

Страница: 21 / 27

Owner's Manual 21
ENGLISH
Setting the Central-Control Address
Setting the Central-Control Address
ON OFF
CANCEL
AUTO CLEAN
SET
(00, ...., 90, A0, ...., F0)
(00, ...., 09, 0A, ...., 0F)
(Address No.3 indoor-unit
of Second Group)
To lower the temperature
To raise the temperature
When RESET button is pressed once with JET COOL button
held, ’00’ will be shown on the LCD DISPLAY and it’ll enter
into the address set mode.
1
Whenever you press the Temperature Increase(UP) button,
the group address number also increases.(Left-digit)
And whenever you press the Temperature Decrease(DOWN)
button, the indoor-unit address number also increases.
(Right-digit) (Control scope of Group Address No. and Indoor-
unit Address No. : 00~FF)
2
When you press the START/STOP button on your remote-
controller directed toward the receiver of indoor-unit after
setting address, the address would be set.
3
When you press RESET button after completing address
setup, the address setup function will be cancelled.
In the state of cancellation, LCD display shows the initial
standby mode.
4
❏
You are recommended to follow below procedure to check indoor-unit address with remote-
controller.
Press RESET button once with the wind direction button( ) of remote-controller held.
The LCD DISPLAY on remote-controller shows ’88’. When you press START/STOP button
on your remote-controller directed toward the receiver of indoor-unit at this time, the display
LED of indoor-unit lights at the initial set address.
NOTICE