LG LT0810CR, Руководство пользователя

Страница: 13 / 48

Owner’s Manual 13
ENGLISH
Installation
PROCEDURE A
If you are using the new sleeve (optionally
supplied with your unit),skip to step 3.
Otherwise, install the plastic grille from the kit.
Cut the plastic grille to 25-1/2" wide and 15-
1/4" high. Place the plastic grille to the inside
of the wall sleeve at the rear flange.
Fasten the 4 washer screws to secure the grille
to the wall sleeve. If you need plastic nuts to
mount plastic grille to the inside of the wall
sleeve, there are plastic nuts in the installation
kit. The nuts are installed from the inside of the
sleeve and are pressing into the square holes
of the rear flanges.
Remove the backing from the Vertical Insulation
strip 15
9/16 x 1 3/8 x 1 3/8 and attach that to the
inside right of the sleeve as shown below.
Remove the backing from the Around Insulation
strip 67
1/8 x 1 3/8 x 25/32 and attach that to the
inside front of the sleeve as shown below.
Install the new unit into the wall sleeve.
To assemble trim, snap the tab of each piece
into the slot of the other piece as shown below.
Slide trim over the front of the air conditioner
until trim is flush with sleeve as shown below.
FIG. 4
Around Insulation
Vertical Insulation
9 1 /
2
" 6"
Indoor Outdoor
FIG. 6
or
FIG. 5
1
2
3
5
Wall
Trim (2 ea)
FIG.
7
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and rear
coils.
• Make sure air conditioner does not fall during
removal.
• If unit does not operate after installation check, to
be sure the circuit interrupter has not been tripped.
Refer to the Troubleshooting guide for reset
procedure.
4