LG LSP-410R, Руководство пользователя

Страница: 7 / 37

13 12
▶
Please observe the following to get better voice
quality.
1. Keep away from electrical appliances such as TV,
computer, radio etc.
2. Keep the phone in a high and central location
without any obstructions.
3. Raise the integral antenna of the phone to get
maximum strength as shown in the figure.
STEP IV. Check the LCD Display
▶
After you follow the installation instruction step I to
step III, please check the LCD for normal operation.
▶
If you do not see the status of service, please repeat
the 4th instruction of step III.
Then confirm the status of phone to get the proper
signal strength from the service operator system.
Introduction
STEP I. Check Components
▶
The following components are supplied Fixed
Wireless Phone.
1. LSP-410R Main Phone with Handset
(Including inner backup battery) -1EA-
2. Dipole Antenna -1EA-
3. AC/DC Power Adapter -1EA-
4. User Guide -1EA-
5. FM Radio Antenna -1EA-
▶
Please make sure that these components are
present before you begin to install the phone. If any
of the components are missing or damaged, contact
your service provider immediately.
STEP II. Place the Terminal
▶
Place the phone on the stable flat surface area
(desk, table, etc.). Serious damage may result if the
phone is dropped. Do not place the phone within 1
meter of heaters or radiators.
This phone is designed for desktop usage. Avoid the
direct exposure to sunlight and dampness.
▶
Read the SAFETY INFORMATION located in the
first part of this document before you place the
phone.
STEP III. Connect Components
(Please refer to “Installation Steps” in 2.4)
▶
Connect the antenna to the TNC antenna
connector located at the top of the phone.
If you have placed the phone on a flat surface,
position the antenna pright.
▶
Connect the curl cord of the handset to the RJ-11
port located on the left side of the phone.
▶
Connect the AC/DC Adapter cable to the DC input
port located at the top of the phone.
-
If it is correct, a beep tone will be heard.
- If it is not correct (Booting fails or beep tone is not
heard), you will have to reconnect the adapter or
reset the battery switch to “on”.
Introduction
Introduction Introduction