Introduction
Introduction
12
You should follow each step carefully as shown below
in order to guarantee the proper operation of CDMA
Fixed Wireless Phone.
STEP I. Check Components
▶
The following components are supplied for Fixed
Wireless Phone.
1. LSI-120R Main Phone with Handset
-1EA-
(Including inner backup battery)
2. Cradle
-1EA-
3. AC/DC Power Adapter
-1EA-
4. User Guide
-1EA-
▶
Please make sure that these components are
present before you begin to install the phone. If
any of the components are missing or damaged,
contact your service provider immediately.
STEP II. Place the Terminal
▶
Place the phone on the stable flat surface area
(desk, table, etc.). Serious damage may result if the
phone is dropped. Do not place the phone within
1 meter of heaters or radiators.
This phone is designed for desktop usage. Avoid
the direct exposure to sunlight and dampness.
▶
Read the Safety Information located in the first
part of this document before you place the phone.
STEP III. Connect Components
(Please refer to “Installation Steps” in 2.5)
▶
Please make sure that the antenna is connected
tightly to the antenna port located on the top side
of the phone.
▶
Connect the AC/DC Adapter cable to the DC
input port located at the right side of the phone.
- If it is correct, a beep tone will be heard.
- If it is not correct (Booting fails the phone will
start to boot), you will have to reconnect the
adapter
▶
Please observe the following to get better voice
quality
1. Keep away from electrical appliances such as
Содержание LSI-120
Страница 2: ......
Страница 4: ...Appendix RF Exposure Statement Appendix 2 Consumer Information on SAR ...