4
x
x
Pattern Function
A routine of manual operations can be stored for 8
minutes at the maximum and reproduced repeti-
tively. The Panning, Tilting and Zoom controls are
available for recording the pattern.
Note:
The available total time of pattern differs
depending on camera’s operation. When the time
is over, the pattern setup will automatically stop.
x
x
Privacy Mask
Privacy zone feature enables users to veil unwant-
ed zones. This setting is used for masking
unwanted zones, hiding them from display on the
monitor screen. Up to 8 zones can be registered.
x
x
Auto Pan
The camera has an Auto Pan function that
enables to keep surveillance on every detail occur-
ring around the specific area, which is preset to
watch in advance.
The camera can pan among the maximum 8
points you will set. The moving speed and holding
time are adjustable.
x
x
Auto Flip
When the camera is operated to tilt through the
90°, it can be watched the opposite side of the
locations by Auto Flip of a 180° horizontally.
x
x
Sophisticated Design
This is the surveillance camera that can fit any
indoor surroundings because it comes in the com-
pact size and sophisticated design.
x
x
Zoom Lens & Auto Focus
Zooming is possible from 27 times (the optical
zoom limit), to a maximum of X2 times digital
zoom.
x
x
Sensor Linkage
The camera is capable of capturing a subject by
the focus of camera moving promptly toward the
subject at the rate of 240°/sec when the camera
works with a detector (magnetic, beam, infrared
rays), and a subject moving within a detection
area is captured by a detector.
x
x
Alarm In function (8 channels)
Alarm input signals are supplied from external
devices through the ALARM IN connector to turn
the camera to a preset position.
x
x
Alarm Out function (4 channels)
When alarm inputs are supplied via the alarm
input connector on the camera, the camera sends
output signals via the alarm output connector on
the camera.
x
x
Controls by General Controller
This camera can be controlled by RS-485.
Especially the camera has an excellent cost-sav-
ing effect because it can be controlled by the gen-
eral RX point of contact signal.
x
x
Connects with the maximum 256 cameras
This camera can be utilized after being connected
with maximum 256 cameras.
Therefore, it is capable of performing an excellent
job in the large buildings or department stores.
x
x
Day & Night Function
This camera can be selected Color or Black &
White. You can set Color in the daytime and Black
& White at night due to the low illumination. (Filter
Conversion type)
x
x
DSS (Digital Slow Shutter) function
It is possible to highly sensitive surveillance
because of DSS(Digital Slow Shutter) function.
x
x
WDR (Wide Dynamic Range) function
The camera can be best condition to watch easily
inside or outside in the strong back light.
Note:
During Auto Pan, Preset Tour, or Pattern
Record/Play, you can use only STOP key or
Joystick on the controller.
x
x
Power Supply
This camera must always be operated a AC 24V
Certified/Listed, class 2 power supply only.
x
x
Heat Pad
The heat pad is installed in this unit. If the unit’s
inside temperature is below than -1°C, the heat
pad is operated to rise the temperature.
LPT-EP500_ENG 12/24/07 1:34 PM Page 4