AB28
MODEL
LNV7210 series
LNV7210R series
Please read this manual carefully before operating
your set and retain it for future reference.
OWNER’S MANUAL
High
Definition
Network
Camera
Warning:
This is a class A product. In a
domestic environment this product may cause
radio interference in which case the user may
be required to take adequate measures.
Warning:
To reduce a risk of fire or electric
shock, do not expose this product to rain or
moisture.
Warning:
Please adopt the power adapter
which can meet the safety extra low voltage
(SELV) standard. And source with DC 12 V or
AC 24 V (depending on models) according
to the IEC60950-1 and Limited Power Source
standard.
Warning:
Install the camera on a ceiling
or wall where can withstand the weight of
5 times of the camera including mounting
bracket.
Caution:
This installation shall be made by a
qualified service person and shall conform to
all local codes.
Caution:
To avoid electrical shock, do not
open the cabinet. Refer servicing to qualified
personnel only.
Caution:
The apparatus shall not be exposed
to water (dripping or splashing) and no objects
filled with liquids, such as vases, shall be
placed on the apparatus.
Caution:
Make sure the power supply voltage
is correct before using the camera.
Caution:
Do not drop the camera or subject it
to physical shock.
Caution:
The sensor may be burned out by
a laser beam, so when any laser equipment is
being used, make sure that the surface of the
sensor not be exposed to the laser beam.
Caution:
While shipping, the camera should
be packed in its original packing.
Note:
Please make sure the product is installed
appropriate places where secured from flood,
such as under the eaves, to operate properly.
This product is certified as IP66 standard.
However, if there is any flood concerns, it
is highly recommended to use an outdoor
Housing. When you install the camera inside
an outdoor Housing, please use one of the
following methods:
1. Remove the front glass of Housing before
installing the camera.
2. To keep the front glass of Housing,
remove the front cover, and then put the
camera close to the front glass.
To disconnect power from mains, pull
out the mains cord plug. When installing
the product, ensure that the plug is easily
accessible.
LG Electronics hereby declares
that this/these product(s)
is/are in compliance with the
essential requirements and
other relevant provisions of
Directive 2004/108/EC and
2011/65/EU.
Contact office for compliance of this
product:
LG Electronics Inc.
EU Representative, Krijgsman 1,
1186 DM Amstelveen, The Netherlands
•
Please note that this is NOT a Customer
Service contact point. For Customer
Service Information, see Warranty Card
or contact the dealer that you purchased
this product.
Disposal of your old appliance
1. When this crossed-out
wheeled bin symbol is
attached to a product
it means the product is
covered by the European
Directive 2002/96/EC.
2. All electrical and electronic products
should be disposed of separately from the
municipal waste stream via designated
collection facilities appointed by the
government or the local authorities.
3. The correct disposal of your old appliance
will help prevent potential negative
consequences for the environment and
human health.
4. For more detailed information about
disposal of your old appliance, please
contact your city office, waste disposal
service or the shop where you purchased
the product.
EEE Compliance with Directive.
(for Turkey only)
Important Safety
Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings.
Install in accordance with the
manufacturer’s instructions.
8. Do not install near any heat sources such
as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that
produce heat.
9. Do not defeat the safety purpose of
the polarized or grounding-type plug.
A polarized plug has two blades with
one wider than the other. A grounding
type plug has two blades and a third
grounding prong. The wide blade or the
third prong are provided for your safety.
If the provided plug does not fit into
your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being
walked on or pinched particularly at
plugs, convenience receptacles, and the
point where they exit from the apparatus.
11. Only use attachments/accessories
specified by the manufacturer.
12. Use only with the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination
to avoid injury from tip-over.
13. Unplug this apparatus during lightning
storms or when unused for long periods
of time.
14. Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
Handling of the unit
Be careful not to spill water or other liquids on
the unit. Be cautious not to get combustible or
metallic material inside the body. If used with
foreign matter inside, the camera is liable to
fail or to get cause of fire or electric shock.
•
Remove dust or dirt on the surface of the
lens with a blower.
•
Use a soft and lint-free, dry cloth(such as
glass cleaner) to clean the body. If it is
very dirty, use a cloth dampened with a
small quantity of neutral detergent then
wipe dry.
•
Avoid the use of volatile solvents such
as thinners, alcohol, benzene and
insecticides.
They may damage the surface finish and/
or impair the operation of the camera.
•
This camera is designed for mounting on
the ceiling or wall. If you install this camera
upside down, it may cause malfunction.
Operating and storage
location
Avoid viewing a very bright object (such as
light fittings) during an extended period. Avoid
operating or storing the unit in the following
locations.
•
Extremely hot or cold places (operating
temperature -10 °C to 50 °C, however, we
recommend that the unit be used within
a temperature range of 0 °C to 45 °C)
•
Damp or dust place
•
Places exposed to rain
•
Places subject to strong vibration
•
Close to generators of powerful
electromagnetic radiation such as radio
or TV transmitters.
•
Do not use the camera in such place
where rapid temperature fluctuation by
switching an air conditioner on and off.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This lightning flash with arrowhead symbol within an equilateral triangle is
intended to alert the user to the presence of uninsulated dangerous voltage
within the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the product.
WARNING
: This product contains chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm.
Wash hands after handling.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless the modifications are
expressly approved in the instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
REGULATORY INFORMATION: FCC Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
•
A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of this
product in the end user.
•
Caution: Danger of explosion if battery is incorrectly replaced. Replaced only with the same or
equivalent type recommended by the manufacturer. Dispose of used batteries according to
the manufacturer’s instructions.
•
Holes in metal, through which insulated wires pass, shall have smooth well rounded surfaces
or shall be provided with brushings.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Warning:
Do not install this equipment in a confined space such as a bookcase or similar unit.
Warning:
Wiring methods shall be in accordance with the National Electric Code, ANSI/NFPA 70.
Item
LNV7210R series
LNV7210 series
Camera
Image Device
6.4 mm (1/2.8 Type) CMOS
Lens Type
3 mm to 9 mm F1.2 (x3 Zoom)
Day / Night
ICR (Auto / Day / Night / External / Schedule)
Minimum
Illumination
Color:
0.03 lx @ F1.2 (1/30 sec, 50 IRE)
B/W:
0 lx @ IR LED on
B/W:
0.003 lx @ F1.2
(1/30 sec, 50 IRE)
WDR
Support
IR Distance
(LNV7210R
only)
20 m
Image
Enhancement
Backlight Compensation, 2D+3D-DNR, De-fog, Exposure Control,
AGC, White Balance, Privacy Masking, Sharpness, EIS, Pivot,
SmartIR (LNV7210R only)
Video /
Audio
Compression
H.264, H.264_High, MJPEG
Resolution
1920 x 1080 / 1280 x 720 / D1 (704 x 576) / CIF (352 x 240)
Maximum
Frame Rate
60 fps @ 1920 x 1080
Multi-
Streaming
Up to 4
ROI (Smart-
Codec)
Support (Up to 8)
Video Analytics
Motion detection, Tampering alarm, Face detection, Intrusion
detection, Crossing line, Object counting, Object removal, Object
desertion
Text Overlay
Support
Audio
Compression
G.711, G.726
2-way Audio
Support
Audio
Detection
Support
Event
Event Trigger
Video analytics, Audio detection, Alarm input
Event
Notification
Relay Out, Email, FTP
Pre Event
Buffering
Support
Interface
Analog Out
BNC out
Audio In / Out
1 / 1
Alarm In / Out
1 In / 1 Out
SD Slot
micro SD (Up to 32 GB)
Network
Ethernet
RJ-45 10 / 100 BASE-T
Security
Password protection, HTTPS (SSL, TLS), IP filtering, IEEE 802.1X
Open Protocol
ONVIF 2.2 Profile S, PSIA 1.1
Protocol
IPv4 and IPv6 :
TCP/IP, UDP, HTTP, HTTPS, RTP, RTSP, DHCP, ICMP,
QoS
IPv4 :
FTP, SMTP, NTP, ARP, SNMP v1/v2c/v3, DDNS(LG)
Integrated
Software
LG Ipsolute VMS Suite / Mobile application (iPhone, iPad,
Android)
Connections
Up to 20
General
Power Source
DC 12 V, PoE
Maximum
Power
Consumption
8.7 W (DC 12 V), 10.4 W (PoE 48 V)
Maximum
Input Current
730 mA (DC 12 V), 280 mA (PoE)
Operation
Temperature /
Humidity
-10 ºC to 50 ºC / 0 % RH to 80 % RH
Dimension
(Ø x H)
140 mm x 122 mm
Weight
980 g
975 g
Component
Camera, CD (Software and Owner’s Manual), Installation Manual, Test monitor cable, Wrench,
Screws (4 EA), Installation sticker, Camera mounting bracket
Specification
a
b
c
d
e
f
g
l
h i jk
a
Dome Cover
b
IR Sensor
(LNV7210R only)
c
IR LED
(LNV7210R only)
NOTE:
Do not stare at operating IR LED within hazard distances (1 m).
d
micro SD card slot
Insert the micro SD card.
e
Jog button
Use this button for control the Zoom / Focus of the camera.
f
Video Out Connector
Use this jack for checking the picture with portable monitor when install the camera.
g
RESET button
Push the button more than 3 seconds, this would restore the factory default network
related settings.
h
AUDIO IN / OUT (Line Level Input/ Output)
i
ALARM IN & OUT / ALARM IN & OUT RETURN
Provides physical interface for sensor and Alarm/Relay.
j
Power input terminal
Connects to a DC 12 V power supply using proper cables. This camera must always be
operated a DC 12 V. Certified/Listed Adaptor which comply with LPS.
k
ETHERNET / PoE Port
Connects to a PC or a network via a hub with a 10 BASE-T / 100 BASE-TX cable attached
RJ-45 connector.
NOTE:
Power over Ethernet (PoE) is a technology that integrates power into a standard LAN
infrastructure. It enables power to be provided to the network device, such as a network
camera, using the same cable as that used for network connection. It eliminates
the need for power outlets at the device locations and enables easier application of
uninterruptible power supplies (LPS).
l
Camera mounting bracket
You can lock the camera mounting bracket by tighten the screws.
Part Names and Functions
