Your microwave oven is shipped with the blower assembled for roof venting. You need to adjust the blower if
you want wall-venting or room-vented (recirculating) installation.
ELECTRICAL SHOCK HAZARD!
UNPLUG UNIT BEFORE WORKING ON IT.
●
DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring
could result in electrical shock.
STEP 3:
PREPARE THE VENTING BLOWER
— 10 —
Figure 10
Figure 11
Figure 12
Figure 14
Figure 13
Mounting plate
Mounting plate screws
Control panel side
blower plate
mounting screw
blower unit
Parts "B"
back plate
blower plate
blower unit
mounting screw
Knockouts Parts "B"
Parts "B"
back Plate
blower
unit
exhaust
ports
back plate
Damper
Exhaust
adaptor
Tapping screw
(Bright color)
W A R N I N G
Remove two screws that attach mounting plate to
microwave oven cabinet. See Figure 10.
Remove mounting plate and set aside. Replace the screws.
ROOF-VENTED INSTALLATION:
1. Insert one side of exhaust adaptor and attach with
the one tapping screw on the other side of exhaust
adaptor to the blower plate.
See Figure 11.
Go to STEP 4 on page 12.
WALL-VENTED INSTALLATION:
1. Remove one blower unit mounting screw and two blower
plate screws. Remove the blower plate from cabinet.
See Figure 12.
2. Carefully lift the blower unit out of the microwave oven.
3. Use side cutters or tin snips to cut and remove knockouts
parts
“B”
from Back plate. Discard knockouts.
Be careful not to distort the plate. See Figure 13.
4. Rotate the unit so that the exhaust ports face the rear of
the cabinet. See Figure 14. When you insert blower unit,
blower wire must be like figure 14.
5. Place blower unit back into cabinet. Check that the
exhaust ports face towards the rear of the cabinet.
See Figure 15.
6. Reattach the blower plate to cabinet so the
exhaust ports and blower plate opening are aligned.
Attach with one blower unit mounting screw and
then two blower plate mounting screws.
See Figure 16.
