LG LK-C1208C02, Руководство по установке

Страница: 20 / 31

20
INSTALLATION OF UNIT
ENGLISH
Connect the cable to the
Product
1
Remove the cover control from the unit by
loosening the screw.
Connect the wires to the terminals on the
control board individually as the following.
2
Secure the cable onto the control board
with the holder (clamper).
3
Refix the cover control to the original posi-
tion with the screw.
4
Use a recongnized circuit breaker between
the power source and the unit. A discon-
nection device to adequately disconnect all
supply lines must be fitted.
Circuit Breaker
(A)
Comply with MOP
* MOP : Maximum Overload Protector
Typical Field wiring Diagram (Figure 6B)
Low Voltage Field Wiring (Figure 6B)
(For three phase electricity product)
High Voltage Field Wiring Diagram (Figure 6C)
(For three phase electricity product)
• See wiring diagram for details.
MAIN PC B ASM
FIELD WIRING
NOTE
FACTORY WIRING
CN10-REMO
REMOTE
CONTROLLER
SEE NAMEPLATE FOR
LINE VOLTAGE AND
MAX FUSE SIZE
3 Ø 3 WIRE
220 V, 60 Hz / 460 V 60 Hz
POWER SUPPLY
HIGH VOLTAGE
MAGNETIC
CONTACTOR
SEE NAMEPLATE FOR
LINE VOLTAGE AND
MAX FUSE SIZE
3 Ø 4WIRE
38 0 V, 60 Hz
38 0-415 V, 50 Hz
POWER SUPPLY
HIGH VOLTAGE
MAGNETIC
CONTACTOR
TERMINAL
B LOCK
Figure 6B
Figure 6C
(
Δ
Connection)
(Y Connection)
Provide flexible conduit supports whenever vi-
bration transmission may cause a noise prob-
lem within the building structure.
See Figure 6C for high voltage wiring connec-
tions. Insure all connections are made tight.
NOTE
!
• For branch circuit wiring (main power
supply to unit disconnect), Wire size for
the length of run should be determined
using the circuit ampacity found on the
unit nameplate and the N.E.C..