5
Introduction
Introduction
About Dome Camera
The dome cameras are designed for installation in an
indoor or outdoor video surveillance system.
The camera incorporates the digital signal processor,
pan/tilt mechanism, x28 zoom lens and RS-485
communication interface in a compact outdoor
enclosure.
Features
m
High Sensitivity Support
The camera provides the high quality picture with
4.5 mm (1/4 Type) Super HAD II CCD.
m
Preset Position
Preset position is the function to register camera
monitoring positions (preset positions). By using
LKD1000 controller, you can register presets
with position number. Maximum 128 Preset
Position are available. By entering the position
numbers, you can move cameras to the preset
positions. The moving speed and holding time are
adjustable.
m
Preset Tour
Preset Tour is the function to go through all the
registered camera monitoring positions (preset
positions).
m
Preset Group Tour
A preset tour is composed of a group of preset
positions that the operator can program to be
linked together in a sequence. A preset group
should have a maximum of 9 preset positions.
m
Pattern recording function
A routine of manual operations can be stored and
reproduced repeatedly. The Pan, Tilt and Zoom
controls are available for pattern recording.
Note:
The available total time of pattern differs
depending on camera’s operation. When the
pattern recording is full, the pattern recording will
automatically stop.
m
Privacy Mask
Privacy zone feature enables users to veil
unwanted zones. This setting is used for masking
unwanted zones, hiding them from display on the
monitor screen. Up to 8 zones can be registered.
m
Auto Pan
The camera has an Auto Pan function that enables
to keep surveillance on every detail occurring
around the specific area, which is preset to watch
in advance.
The camera can pan among the maximum 8
points you will set. The moving speed and holding
time are adjustable.
m
Auto Flip
When the camera is operated to tilt through the
90°, it can be watched the opposite side of the
locations by Auto Flip of a 180° horizontally.
m
Optical Zoom
The optical zoom range is 1x to 28x.
m
Digital Zoom
Digital zoom enhances the systems zoom range
to 12 times beyond the 28x optical zoom limit. By
utilizing the digital zoom function, the total system
zoom range increases further from 28x (1x digital
zoom) to 336x (12x digital zoom)
m
Sensor Linkage
The camera is capable of capturing a subject by
the focus of camera moving promptly toward the
subject at the rate of 120° / s when the camera
works with a detector (magnetic, beam, infrared
rays), and a subject moving within a detection area
is captured by a detector.
m
Alarm In function
Alarm input signals are supplied from external
devices through the ALARM IN connector to
activate 'go to preset' function.
m
Controls by General Controller
This camera can be controlled by RS-485.
Especially the camera has an excellent cost-
saving effect because it can be controlled by the
general RX point of contact signal.
m
Connects with the maximum 256 cameras
This camera can be utilized after being connected
with maximum 256 cameras.
Therefore, it is capable of performing an excellent
job in the large buildings or department stores.
