Mechanical Instructions
EN 5
LCD LPL 2K7
4.
4.
Mechanical Instructions
Index of this chapter:
4.1 General
4.2 Model LC260WX2
4.3 Model LC320W01
4.4 Model LC320WX2
4.5 Model LC370WX1
4.6 Model LC420WU2
4.7 Model LC420WU4
4.8 Model LC420WX2
4.9 Model LC420WX3
4.10 Model LC420WX5
4.11 Model LC470WU1
4.12 Model LC470WU4
4.1
General
4.1.1
Warnings
•
Figures can deviate due to the different module executions.
•
During repair, place the set face down on a soft surface
(e.g. on foam bars as mentioned in next paragraph), in
order to prevent damaging the display.
Note:
With some chassis, it is possible to measure and
replace the boards while the TV is still on its stand.
•
All ICs and many other semiconductors are susceptible to
electrostatic discharges (ESD
w
). Careless handling
during repair can reduce life drastically. Make sure that,
during repair, you are connected with the same potential as
the mass of the set by a wristband with resistance. Keep
components and tools also at this same potential.
Figure 4-1 ESD wristband
•
Be careful during measurements in the high voltage
section. Never pull plugs out under operation conditions,
just to prevent danger caused by electrical sparks.
•
Never replace modules or other components while the unit
is switched “on”.
•
Connectors “to” and “from” the Inverter Boards must be
thoroughly connected to avoid any electrical sparks during
operation.
4.1.2
Inverter repair policy
Note:
When an LCD display has a “master” and “slave” inverter
configuration, and one of these boards is defective, it is advised
to replace
both
the inverter boards (due to matching reasons).
4.1.3
Foam Bars
Figure 4-2 Foam bars
The foam bars (order code 3122 785 90580 for two pieces) can
be used for all types and sizes of flat displays. See figure
“Foam bars” for details. Displays with a size of 42” and larger,
require
four
foam bars [1]. Ensure that the foam bars are
always supporting the cabinet and
never
only the display.
Caution:
Failure to follow these guidelines can seriously
damage the display!
By laying the TV face down on the (ESD protective) foam bars,
a stable situation is created to perform measurements and
alignments. By placing a mirror under the display, you can
monitor the screen.
4.1.4
Torque Values
Table 4-1 Recommended Torque Values
H_16
9
20_001
.e
p
s
060407
Screw Type (cross head)
Recommended Torque Value
M2
2.0 kg*F ± 0.1 kg*F
M2.5
3.0 kg*F ± 0.5 kg*F
M2.6
3.0 kg*F ± 0.5 kg*F
M3
6.0 kg*F ± 0.5 kg*F
E
_
06532
_
018.eps
171106
1
Required for sets
42"
1
