INSTALLATION
Installing the camera on a ceiling or wall
. Affix the mounting template(supplied) to the mounting surface.
. Secure the camera mounting bracket to the position where the camera
should be mounted with the supplied screws.
Tapping Type ø4x20mmx3ea
(Supplied)
. Adjust the camera lens to face the area to be monitored and fix the main body and the
dome cover by aligning the grooves and rotating the body clockwise.
ADJUSTMENT
FAR
NEAR
TELE
WIDE
Service Monitor
TILT 80
˚
(Viewable operation
tilt angle 60
˚~
65
˚
)
PAN 360
˚
ROTATE 360
˚
1. Having a better view , adjust the camera
•
Rotate angle : 360˚
•
Panning angle : 360˚
•
Tilting angle : 80˚(Viewable operation tilt angle 60˚~65˚)
2. Follow the instruction provided below to make any lens adjustments.
• Loosen the Zoom & Focus screws.
•
Using the screw, move it LEFT or RIGHT to the desired position.
•
Once the desired adjustments have been made, tighten the screw to lock in place.
•
Adjust the Field of View by moving the screw towards the LEFT(Tele) to
zoom in, or towards the RIGHT(Wide) to zoom out.
•
Adjust the Focus the same way as described above after the desired zoom
position is established.
Focus
: Far
←
→
Near
Zoom
: Tele
←
→
Wide
Service Video connector
The Service Video Connector also provides the installer with an easy way
of configuring the camera.
Tapping Type
ø2x7mmx1ea
(Supplied)
Diffused reflection can occur when IR is covered. In this case, the setting as below is required.
Caution: Be careful not to cover the sensor when installing a device.
1. 180˚rotation in LED Part as shown in the picture
2. OSD MENU Setting
SPECIAL: D-EFFECT ; ROTATE
SPECIAL
LANGUAGE
COLOR EFFECT
SHARPNESS
STABILIZER
D-ZOOM
D-EFFECT
MOTION DET
FACTORY RESET
RETURN
ENG
ON
34 ………I……
OFF
OFF
ROTATE
OFF
