To Install as a Slave Drive
To install the drive as a Slave, change the jumper setting on the rear panel to SL.
Connecting the Power Connector
Connect the power cable from the computer’s power supply to the socket on the drive
unit, fitting the connector firmly into the power in connector. If there is no spare power
cable available in the computer, you will have to purchase a splitter cable of a suitable
type.
Connecting the Interface Connector
Connect the 40-pin IDE cable to the back of the Super Multi DVD Drive, making sure
the coloured (red) stripe on the IDE cable is connected to pin 1 on the Super Multi
DVD drive (Pin 1 is closest to the Power Connector).
6
Slave drive
(Super Multi
DVD Drive)
(Jumper set to
Slave)
Master drive
(Booting hard disk)
- OR -
DIGITA
L
ANALOG
INTERFACE
POWER
D
R
C S M
S L A
G L
G
39
1
+5
+12
GND
40
2
AUDIO
AUDIO
Secondary
connector
Master drive
(Other IDE drive)
Slave drive
(Super Multi
DVD Drive)
(Jumper set
to Slave)
DIGITAL
ANALOG
INTERFACE
POWER
D
R
C S M
S L A
G L
G
39
1
+5
+12
GND
40
2
AUDIO
AUDIO
DIGITAL
ANALOG
INTERFACE
POWER
D
R
C S M
S L A
G L
G
39
1
+5
+12
GND
40
2
AUDIO
AUDIO
Master drive
(Booting hard disk)
Primary
connector
Beveled edge up
NOTE
: Improper connection may
damage the drive and void the warranty.
Generally, the power connector can only
fit one way.
Pin1
Red-edge
NOTE
: Generally, the IDE connector is
keyed and will only fit one way.
