USING YOUR REFRIGERATOR
ENSURING PROPER AIR
CIRCULATION
In order to ensure proper temperatures, air must
flow between the refrigerator and freezer
sections. As shown in the illustration below, air
enters at top of freezer and circulates down.
From bottom of freezer, air is forced up to top of
refrigerator. Air enters refrigerator through top
vent, then circulates and exists at bottom, where
it returns to freezer.
MULTI-FLOW
• Multi-Flow means powerful and effective cooling
operation. This is especially noticeable when
new food is placed in the refrigerator
compartment.
• If water or foreign substances enter the cool air
vent while cleaning, efficiency will be lowered. In
addition, if gasket is damaged, efficiency may
be lowered because of escaping cool air.
Do not block any of cool air vents
with food
packages. If the vents are blocked, airflow will be
interrupted and temperature and moisture
problems may occur.
IMPORTANT:
Because air circulates between
both sections, any odors formed in one section
will transfer to the other. You must thoroughly
clean both sections to eliminate odors. To
prevent odor transfer and drying out of food, wrap
or cover foods tightly. (See the Food Storage
Guide section for details.)
SETTING THE CONTROLS
• Your refrigerator has a control pad on the
dispenser that lets you regulate the temperature
in the freezer and refrigerator compartments.
• Initially set the REFRIGERATOR CONTROL at
3°C and the FREEZER CONTROL at –18°C.
Leave it at this setting for 24 hours (one day) to
stabilize. Then adjust the compartment
temperature as desired.
• Refrigerator Temp Control: 0°C to 8°C
The lower the number setting, the colder the
refrigerator compartment will become.
• Freezer Temp Control: -21°C to -13°C
When the setting is at a lower number, the
freezer compartment becomes colder. But the
refrigerator compartment becomes warmer
because less cold air flows into the refrigerator.
NOTE:
If you want to off display, press and hold
EXPRESS FRZ key and FREEZER key over 5
seconds at the same time.
NOTE:
Touch display once to activate, then
touch again to change the settings or activate a
function. If 10 seconds has passed since the
display has been touched, it will be necessary to
touch “once” again to reactivate.
☞
This is to prevent accidental display setting
changes.
• Express Freezing : Press the EXPRESS FRZ
button and the LED will turn on. This function
will remain activated for 24 hours and increase
the cooling speed of the freezer and the amount
of ice produced.
• Dispenser Lock : Press and hold the LOCK
button for 3 seconds to lock the dispenser.
When it is locked, the LED will be off and the
dispenser will not operate. To unlock, press and
hold the LOCK button for 3 seconds.
• Filter Reset : When the FILTER RESET LED
turns on, you have to change the water filter.
Press the FILTER RESET button for 3 seconds
to turn LED off. You need to change the water
filter approximately every 6 months.
w
w
WARNING:
If a door is open, the dispenser
does not work.
14