LG GM-F208ST, Руководство пользователя

Страница: 12 / 42

12
REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION
WARNING
EXCESSIVE WEIGHT HAZARD
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
UNPACKING YOUR REFRIGERATOR
Remove tape and any temporary labels from
your refrigerator before using. Do not remove any
warning-type labels, the model and serial number
label, or the TechSheet that is attached to back
wall of the refrigerator.
To remove any remaining tape or glue, rub the
area briskly with your thumb. Tape or glue residue
can also be easily removed by rubbing a small
amount of liquid dish soap over the adhesive with
your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol,
flammable fluids or abrasive cleaners to remove
tape or glue. These products can damage the
surface of your refrigerator. For more information,
see the
Important Safety Instructions
section.
Refrigerator shelves are installed in the shipping
position
WARNING
When Moving Your Refrigerator :
Your refrigerator is heavy. When moving
the refrigerator for cleaning or service, be
sure to protect the floor. Always pull the
refrigerator straight out when moving it.
Do not wiggle or walk the refrigerator when
trying to move it, as floor damage could
occur.
WARNING
EXPLOSION HAZARD
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion or
fire
.
Please reinstall shelves according to your
individual storage needs.
• To reduce the risk of electric shock, do not install
the refrigerator in a wet or damp area.
CAUTION: Avoid placing the unit near heat
sources, direct sunlight or moisture.
INSTALLATION
• To minimize noise and vibration, the refrigerator
MUST be installed on a solidly constructed floor.
• Carpeting and soft tile surfaces are not
recommended.
• Never install the refrigerator on a platform or
weakly supported structure.
1. To avoid vibration, the unit must be level. If
required, adjust the leveling screws to
compensate for unevenness of the floor. The
front should be slightly higher than the rear to
aid in door closing. Leveling screws can be
turned easily by tipping the cabinet slightly. Turn
the leveling screws clockwise ( ) to raise the
unit, counterclockwise ( ) to lower it.
2. Install this appliance in an area where the
temperature is between 13°C and 43°C. If the
temperature around the appliance is too low or
high, cooling ability may be adversely affected.
3. Too small a distance
from adjacent items
may result in lowered
freezing capability and
increased electricity
consumption charges.
Allow at least 24 in.
(61 cm) in front of the
refrigerator to open the
doors
NEXT
1. Clean your refrigerator thoroughly and wipe off
all dust accumulated during shipping.
2. Install accessories such as ice cube bin,
drawers, shelves, etc., in their proper places.
They are packed together to prevent possible
damage during shipment.
3. Let your refrigerator run for at least 2 or 3
hours before putting food in it. Check the flow
of cold air in the freezer compartment to ensure
proper cooling. Your refrigerator is now ready for
use.
WARNING:
• Take care when working with the hinges, base
cover and stops, etc. You may injure yourself.
• DO not place your hands or any tools in the
air vents, the base cover or in the bottom of the
refrigerator. This may cause injury or electrical
shock
.
BASE COVER (BASE GRILLE).
To remove the base cover
1. Open the Freezer Drawer. (Drawer not shown
for clarity.)
2. Once drawer is open there is sufficient
clearance to remove screws on top of cover.
To replace base cover:
• Place cover into position
and insert and tighten screws.