DirectCD
TM
v2.5b(s)
Installation
8
Jumper Setup
Before installation, set the jumper on the jumper connector on the rear
panel.
The drive can be connected as the Master or Slave on an EIDE (ATAPI)
interface. When several (up to four) EIDE devices are connected, each
must be set in a unique way. Specific knowledge of hardware and
software is necessary to install the drive.
NOTE
: If two peripheral devices with the same settings are both con-
nected to the Primary or to the Secondary EIDE bus, the host computer
may fail to run or may malfunction. Careful attention is necessary.
DIGITAL
AUDIO
ANALO
G
AUDIO
INTERF
ACE
POWER
D G
39
40
1
+5
GND
+12
2
C S M
S L A
R G
L
AL
O
R G L
C S M
S L A
39
40
ANALOG
AUDIO
CS: Cable Select (CSEL)
SL: Slave
MA: Master
NOTE :
Only one jumper should be installed on the jumper connector.
If more than one jumper is installed, the drive may malfunction or be
damaged.
Master/Slave setting is determined by jumper installation on the Jumper
Connector. The following table shows the possible jumper settings.
If you use CSEL setting, the MASTER/SLAVE setting will be made
automatically, depending on the hardware configuration.
For details refer to the manual of your computer.
Name
Function
Drive set as Master
Drive set as Slave
Drive mode set by CSEL on the
host IDE interface
MA
(Master)
SL
(Slave)
CS
(Cable Select)
C
S
S
L
M
A
