LG GA-B3 9B QA Series, Руководство пользователя

Страница: 45 / 64

Installation
45
1. Select a good location.
Place your fridge-freezer where it is easy to use.
2. Avoid placing the unit near heat sources,
direct sunlight or moisture.
4. To ensure proper air circulation around the fridge -freezer,
please maintain sufficient space on both the sides as well as top
and maintain at least 2 inches (5 cm) from the rear wall. (pic.2)
5. Please, do not remove the round stickers on the back side
of the refrigerator. They are performing decoration functions
by closing technological holes.
6. To avoid vibration, the unit must be leveled. If required, adjust
the leveling screws to compensate for the uneven floor.
The front should be slightly higher than the rear to aid in
door closing. Leveling screws can be turned easily by tipping
the cabinet slightly.
Turn the leveling screws counterclockwise ( ) to raise
forward part of a refrigerator, clockwise ( ) to lower it.
7. Before use clean your fridge-freezer thoroughly.
8. Install accessories such as ice cube box, etc., in their
proper places. They are packed together to prevent
possible damage during shipment.
9. Connect the power supply cord (or plug) to the outlet.
Don't double up with other appliances on the same outlet.
When your fridge-freezer is installed, allow it 2-3 hours at normal
operating temperature prior to filling it with fresh or frozen foods.
If power plug is disconnected, allow 5 minutes delay
before restarting.
Your fridge-freezer is now ready for use.
Installation
Starting
The appliance is designed to operate in a limited range
of ambient temperature, depend on climatic zones. You are
not allow to go for any lower, either from the top of the range.
Climatic class of your appliance marked on the Label
specification with technical description in inner side of the
refrigeration compartment.
Climatic class
Admissible ambient
temperature
+10 32
+18 43
+18 38
+16 32
SN
N
T
ST
o
o
o
o
o
o
o
o
Climatic class
3. To provide necessary of air circulation, you should leave
enough space behind, on each side and top of refrigerator-
freezer. Set the limit stops in the upper corners of the back
plate of the device as shown in picture 1.