13
INSTALLATION
ENGLISH
Then tighten the four lock nuts. All lock nuts
must be tightened.
NOTE
• The Mini Washer will not work as a stand-alone
unit.
Connecting the Water
Supply Hose
Needed Accessories
*1 The included accessories vary depending on the
model you purchased.
a
Water Supply Hose(for cold water)
b
Connecting Supply Hose and Disassembled
Connector
*1
c
Connecting Supply Hose with Assembled
Connector
*1
Note for Connection
• Water pressure must be between
50 kPa
and
800 kPa
(0.5 – 8.0 kgf/cm²). If the water pressure
is more than
800 kPa
, a decompression device
should be installed.
• Periodically check the condition of the water
supply hose and replace the water supply hose if
necessary.
NOTE
• If the water pressure is near or over 800 kPa, a
water pressure reduction device should be
installed to both taps.
• Exceeding 65
℃
can damage some clothes.
• Temperatures below 4
℃
can cause hoses to
freeze and burst and unfavourable wash results
due to undissolved detergent.
• Cold inlet Water Temperatures over 25
℃
can
cause damage to clothes such as delicate
Woollens
• Do not overtighten the water supply hose or use
mechanical devices to tighten onto the inlet
valves.
• No further backflow protection is required for
connection to the water inlet.
Checking the Rubber Seal
Two rubber seals
a
are supplied with the water
supply hose. They are used to prevent water leaks.
Connection to taps is sufficiently tight.
• Do not use mechanical devices such as multi
grips to tighten the water supply hose. Ensure
that the curved end of the water supply hose is
connected to the appliance.
global_main.book.book Page 13 Tuesday, March 23, 2021 3:42 PM
