36
EN
Cleaning the Dispenser
Drawer
Detergent and fabric softener may build up in
the dispenser drawer. Remove the drawer and
inserts and check for buildup once or twice a
month.
1
Remove the detergent dispenser drawer by
pulling it straight out until it stops.
•
Press down hard on the disengage button
and remove the drawer.
2
Remove the inserts from the drawer.
•
Rinse the inserts and the drawer with
warm water to remove buildup from
laundry products. Use only water to clean
the dispenser drawer. Dry the inserts and
drawer with a soft cloth or towel.
3
To clean the drawer opening, use a cloth or
small, non-metal brush to clean the recess.
•
Remove all residue from the upper and
lower parts of the recess.
4
Wipe any moisture off the recess with a soft
cloth or towel.
5
Return the inserts to the proper
compartments and replace the drawer.
Tub Clean (Optional)
Tub Clean is a special programme to clean the
inside of the washing machine.
A higher water level is used in this programme
at higher spin speed. Perform this programme
regularly.
1
Remove any clothing or items from the
washing machine and close the door.
2
Open the dispenser drawer and add
anti-limescale (e.g. Calgon) to the main
wash compartment.
•
For tablets put into the drum.
3
Close the dispenser drawer slowly.
4
Power on and then press and hold
Rinse+
and
Delay End
button for 3 seconds. Then
will be displayed on the display.
5
Press the
Start/Pause
button to start.
6
After the programme is complete, leave the
door open to allow the washing machine
door opening, flexible gasket and door glass
to dry.
CAUTION
•
If there is a child, be careful not to leave the
door open for too long.
NOTE
•
Do not add any detergent to the detergent
compartments. Excessive suds may generate
and leak from the washing machine.
EN
Caution on Freezing During
Winter
•
When frozen, the product does not operate
normally. Make sure to install the product
where it will not freeze during winter.
•
In case the product must be installed outside
on a porch or in other outdoor conditions,
make sure to check the following.
How to Keep the Product from
Freezing
•
After washing, remove water remaining inside
the pump completely with the opening hose
plug used for removal of residual water. When
the water is removed completely, close the
hose plug used for removal of residual water
and cover cap.
Drain plug
Cover cap
•
Hang down drain hose to pull out water inside
the hose completely.
Drain hose
CAUTION
•
When the drain hose is installed in a curved
shape, the inner hose may freeze.
•
After closing the tap, disconnect the cold
supply hose from the tap, and remove water
while keeping the hose facing downwards.
Supply hose
Check for Freezing
•
If water does not drain when opening the hose
plug used for removal of residual water, check
the drainage unit.
Drain plug
Cover cap
•
Turn the power on, choose a washing
programme, and press the
Start/Pause
button.
Drain hose
Detergent drawer
•
When '
' is shown in display window while
the product is in operation, check water supply
unit and drainage unit (Some models do not
have an alarm function that indicates
freezing).
NOTE
•
Check that water is coming into the detergent
drawer while rinsing, and water is draining
through the drain hose while spinning.
Содержание F4J7JS(P)(0~9)W/S
Страница 47: ...Memo ...
Страница 48: ......
