Owner's Manual
13
This operation circulates the air without cooling or heating. It can
be activated by pressing the AIR CIRCULATION BUTTON. Once
the air circulation is activated you can select the air speed by
pressing the INDOOR FAN SPEED SELECTOR BUTTON.
The up/down airflow (Vertical airflow) can be
adjusted by using the remote controller.
1. Press the START/STOP BUTTON to start the
unit.
2. Press CHAOS SWING BUTTON.
3. The louvers will swing up & down
automatically.
4. To stop the louver at a desired angle,
press again
To adjust left/right (Horizontal Airflow) direction
Adjust the left/right airflow direction by hand.
: While adjusting vertical airflow direction
louvers, be careful not to touch the evaporator.
Operating Instructions
Vertical / Horizontal Airflow Direction Control
• By pressing the CHAOS SWING BUTTON the horizontal air flow direction is changed automatically based on the chaos
algorithm to distribute the air in the room evenly and at the same time to make the human body feel most comfortable as if
enjoying natural breeze.
• Always use the remote controller to adjust the up and down air flow direction. Manually moving the vertical air flow
direction louver by hand could damage the mechanism.When the unit is shut off, the up/down airflow direction louver will
close the air outlet vent of the system.
NOTE
CHAOS Air economizes power consumption and prevents overcooling. The fan speed is automatically
changed from high to low or vice versa, depending on the ambient temperature.
NOTE
In case the power comes on again after a power failure, the unit operates automatically to the previous operating
conditions.
So there is no need of activating this function by pressing any key or button.
In the initial mode, the fan operates at a low speed and the compressor starts about 3 minutes later.
As the compressor starts, the fan speed also resumes its previous setting mode.
: In case of absence for a long time while power failure, turn off main power to avoid undesired Auto
restart.
Air Circulation Mode
Auto Restart Function
