9
2-3. CONNECT THE DRAIN HOSE
CAUTION
Hose
Guide
0.9~1.2m
Drain Hose
Within 50mm
·
Connect the drain hose to
the outlet of the drain pump
located at the rear of the
washing machine.
·
Attach the clip to the drain
hose. And then push it toward
the body of the washing
machine as indicated by the
arrow.
·
Check that the drain hose is
hung up over the edge of the
laundry tub.
·
Do not use an extension hose.
·
Connect the drain hose to the outlet of the
drain located at the back side of the
washing machine.
·
Fix the drain hose with the clip.
And then push it toward the body as in the
figure.
·
Keep it downward while the washing machine
is working.
·
Ensure the hose is free from kinking.
·
Never lay down the drain hose, as water will be discharged.
·
Be sure the drain hose is properly routed so it will not kink
or lift from the sink.
·
The discharge height should be approximately 0.9~1.2m from
the floor.
·
Connect the drain hose adjusting the length of it not to be
dropped. If drain hose is dropped the drainage could be poor
because of blockage in the hose.
·
NOTE
:
·
Do not install the washer where it is directly exposed to sunlight, wind, rain etc.
·
Plug the power cord of this washer into a properly installed standard electrical outlet
that is switched & earthed.
■
For pump model
■
For non - pump model
