LG B120AH, Руководство пользователя

Страница: 14 / 21

14 Large Duct-Type Air Conditioner
Operating Instructions
AUTO SWING
ZONE
Operation unit Program set
Room Temp
MED
LO
AUTO
JET Heater
Defrost
Filter
Humidify
Out door
Time
Timer
On
Set no. Time Off
01 03 05 07 09 11 13 15 17 19 21 23
1 2 3 4
OPERATION FAN SPEED SUB FUNCTION SET TEMP
HI Preheat
HEAT PUMP MODEL
AUTO SWING
ZONE
Operation unit Program set
Room Temp
MED
LO
AUTO
JET Heater
Defrost
Filter Preheat
Humidify
Out door
Time
Timer
On
Set no. Time Off
01 03 05 07 09 11 13 15 17 19 21 23
1 2 3 4
OPERATION FAN SPEED SUB FUNCTION SET TEMP
HI
AUTO SWING
ZONE
Operation unit Program set
Room Temp
MED
LO
AUTO
JET Heater
Defrost
Filter Preheat
Humidify
Out door
Time
Timer
On
Set no. Time Off
01 03 05 07 09 11 13 15 17 19 21 23
1 2 3 4
OPERATION FAN SPEED SUB FUNCTION SET TEMP
HI
COOLING MODEL
To raise the Temperature.
To lower the Temperature.
To raise the Temperature.
(When you feel too cool or cold.)
To lower the Temperature.
(When you feel too warm or hot.)
Cold Cool Proper Warm Hot
For Heat Pump Models only
Soft Dry Operation Mode
5
If the outdoor temperature is too low during the
heating operation, this air-conditioner is set to the
defrosting operation and the remote controller
indicates ‘Defrost’.
Auto Operation Mode(Heat Pump/Cooling Models)
During Auto Operation:
❏
You can switch the indoor fan speed.
❏
In case of heat Pump Models, the system will automatically switch from the cooling mode to the heating
mode as the room temperature and set temperature.(Auto changeover)
Set the temperature lower than the room themperature.
The temperature can be set within a range of 18˚C ~ 30˚C by 1˚C.
Set the temperature upper or lower than the standard temperature.
The temperature can be set within a range of
-2 ~ 2 by 1 level.
(This indication will be shifted to the initial
Auto Mode Display state after 4 seconds.)
6
Soft Dry Operation is used to remove the humidity softly without overcooling the room
specially when the humidity is already low.
The indoor fan speed is automatically set to the low, so it can’t be changed as it is already
being set to the best speed for Soft Dry Operation by Micom Control.
7