ENGLISH
Installation Manual
7
Installation
Read completely, then follow step by step.
Installation
Selection of the best location
CAUTION : In case that the unit is installed near the sea, the installation parts
may be corroded by salt. The installation parts (and the unit) should be taken
appropriate anti-corrosion measures.
•
There should not be any heat source or steam
near the unit.
• There should not be any obstacles to prevent the
air circulation.
• A place where air circulation in the room will be
good.
• A place where drainage can be easily obtained.
• A place where noise prevention is taken into con-
sideration.
• Do not install the unit near the door way.
• Ensure the spaces indicated by arrows from the
wall, ceiling, fence, or other obstacles.
The mounting wall should be strong and solid
enough to protect it from the vibration.
Mount the installation plate on the wall with four
Type "A" screws.
(If mounting the unit on the concrete wall, consid-
er using anchor bolts.)
• Always mount the Installation plate horizontally
by aligning the marking-off line by means of the
thread and a level.
More than
200mm(7-7/8 inch)
More than
100mm(3-15/16 inch)
More than
2300mm
(90-9/16 inch)
More than
100mm(3-15/16 inch)
Chassis
Hook
Installation Plate
Type “A”
SE chassis
S8 chassis
Chassis
Hook
Installation Plate
Type “A”
Ø70mm
(2-3/4 inch)
110mm
(4-5/16 inch)
Ø70mm
(2-3/4 inch)
110mm
(4-5/16 inch)
65mm(2-9/16 inch)
85mm(3-3/8 inch)
S8 chassis
SE chassis
Installation plate
Left rear piping
Right rear piping
Installation plate
Left rear piping
Right rear piping
Ø70mm
(2-3/4 inch)
133mm
(5-1/4inch)
Ø70mm
(2-3/4 inch)
100mm
(3-15/16inch)
The lower left and the right side of Installation Plate
